Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Use of pulverised coal in boilers provides
Options- A. higher calorific value
- B. better combustion
- C. smokeless burning
- D. less erosion on furnace wall.
- Correct Answer
- better combustion
- 1. Air filtration in a furnace
Options- A. reduces its thermal efficiency.
- B. is indicated by flame sting out.
- C. increases the flue gas temperature.
- D. none of these. Discuss
- 2. The heating capacity of muffle furnace depends on the
Options- A. surface area & emissivity of the stock.
- B. properties of the muffle wall (temperature, area, emissivity).
- C. both (a) & (b)
- D. neither (a) nor (b) Discuss
- 3. The electric furnace in which heat is produced by a combination of induced current and skin effect is called __________ furnace.
Options- A. arc
- B. resistance
- C. low frequency induction
- D. high frequency induction Discuss
- 4. The main function of a muffle in the muffle furnace is to
Options- A. protect the charge from the effects of the products of combustion.
- B. smooth out temperature inequalities on the combustion side of the muffle wall.
- C. both (a) & (b)
- D. neither (a) nor (b) Discuss
- 5. Thermal efficiency of furnaces can be improved by
Options- A. waste heat recovery from flue gas.
- B. minimising heat losses from furnace walls.
- C. maintaining proper draught.
- D. all (a), (b) and (c). Discuss
- 6. Which of the following furnaces will have maximum thermal efficiency?
Options- A. Soaking pits
- B. Walking beam reheating furnace
- C. Boiler furnace
- D. Rotary kilns Discuss
- 7. Regenerators compared to the recuperators for the same duty
Options- A. occupy more space
- B. are less costly
- C. are of smaller size
- D. all (a), (b) and (c) Discuss
- 8. Overall thermal efficiency of a lumpy coal fired suitably designed heating furnace, if operated & maintained properly may be about __________ percent.
Options- A. 10-15
- B. 25-30
- C. 45-50
- D. 65-70 Discuss
- 9. Heat balance of furnace provides means of determining the
Options- A. thermal efficiency of the process.
- B. sources of heat losses.
- C. scope of reduction of heat losses.
- D. all (a), (b) and (c). Discuss
- 10. Hearth furnaces are not used for
Options- A. roasting
- B. melting
- C. reheating
- D. none of these Discuss
Furnace Technology problems
Search Results
Correct Answer: reduces its thermal efficiency.
Correct Answer: both (a) & (b)
Correct Answer: high frequency induction
Correct Answer: both (a) & (b)
Correct Answer: all (a), (b) and (c).
Correct Answer: Boiler furnace
Correct Answer: occupy more space
Correct Answer: 25-30
Correct Answer: all (a), (b) and (c).
Correct Answer: none of these
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.