Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Thermal efficiency of furnaces can be improved by
Options- A. waste heat recovery from flue gas.
- B. minimising heat losses from furnace walls.
- C. maintaining proper draught.
- D. all (a), (b) and (c).
- Correct Answer
- all (a), (b) and (c).
- 1. Turn down ratio of a burner
Options- A. should be as low as possible i.e., 1 : 2.
- B. should be 1:1 for a batch type furnace..
- C. is the ratio of maximum to minimum permissible heat input rates.
- D. is normally much more for a continuous furnace as compared to a batch furnace. Discuss
- 2. Which of the following is a directly fired intermittant furnace?
Options- A. Walking beam reheating furnace
- B. Reverberatory furnace
- C. Tower furnace
- D. Tunnel kiln Discuss
- 3. Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the
Options- A. quantity & temperature of waste gas.
- B. dust concentration & nature of dust in waste gas.
- C. corrosive nature of the waste gas.
- D. all (a), (b) and (c). Discuss
- 4. Scaling of furnace stock is reduced by __________ in flue gas.
Options- A. CO
- B. H2
- C. high CO/CO2
- D. all (a), (b) & (c) Discuss
- 5. Regenerators are normally provided in the
Options- A. glass melting furnace.
- B. open hearth furnace.
- C. by product coke ovens.
- D. all (a), (b) and (c). Discuss
- 6. The main function of a muffle in the muffle furnace is to
Options- A. protect the charge from the effects of the products of combustion.
- B. smooth out temperature inequalities on the combustion side of the muffle wall.
- C. both (a) & (b)
- D. neither (a) nor (b) Discuss
- 7. The electric furnace in which heat is produced by a combination of induced current and skin effect is called __________ furnace.
Options- A. arc
- B. resistance
- C. low frequency induction
- D. high frequency induction Discuss
- 8. The heating capacity of muffle furnace depends on the
Options- A. surface area & emissivity of the stock.
- B. properties of the muffle wall (temperature, area, emissivity).
- C. both (a) & (b)
- D. neither (a) nor (b) Discuss
- 9. Air filtration in a furnace
Options- A. reduces its thermal efficiency.
- B. is indicated by flame sting out.
- C. increases the flue gas temperature.
- D. none of these. Discuss
- 10. Use of pulverised coal in boilers provides
Options- A. higher calorific value
- B. better combustion
- C. smokeless burning
- D. less erosion on furnace wall. Discuss
Furnace Technology problems
Search Results
Correct Answer: is the ratio of maximum to minimum permissible heat input rates.
Correct Answer: Reverberatory furnace
Correct Answer: dust concentration & nature of dust in waste gas.
Correct Answer: all (a), (b) & (c)
Correct Answer: all (a), (b) and (c).
Correct Answer: both (a) & (b)
Correct Answer: high frequency induction
Correct Answer: both (a) & (b)
Correct Answer: reduces its thermal efficiency.
Correct Answer: better combustion
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.