Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
__________ furnace is not an electric furnace.
Options- A. Arc
- B. Induction
- C. Pot
- D. Resistance.
- Correct Answer
- Pot
- 1. In which of the waste heat recovery equipment, the flow of flue gas and air is alternately reversed after a fixed interval of time?
Options- A. Recuperator
- B. Regenerator
- C. Waste heat boiler
- D. None of these Discuss
- 2. Which is a regenerative furnace?
Options- A. Coke oven heating chamber.
- B. Open hearth furnace.
- C. Both (a) and (b).
- D. Neither (a) nor (b). Discuss
- 3. Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600°C, the percentage stack loss will be maximum in case of complete combustion of
Options- A. furnace oil with air.
- B. furnace oil with oxygen.
- C. blast furnace gas with air.
- D. blast furnace gas with oxygen. Discuss
- 4. Shaft furnaces are used for
Options- A. smelting
- B. calcining
- C. roasting
- D. all (a), (b) and (c) Discuss
- 5. Heat transfer takes place through a liquid medium surrounding the submerged material under heating, in case of a/an
Options- A. blast furnace.
- B. steam boiler.
- C. salt bath furnace.
- D. annealing furnace. Discuss
- 6. Regenerators are normally provided in the
Options- A. glass melting furnace.
- B. open hearth furnace.
- C. by product coke ovens.
- D. all (a), (b) and (c). Discuss
- 7. Scaling of furnace stock is reduced by __________ in flue gas.
Options- A. CO
- B. H2
- C. high CO/CO2
- D. all (a), (b) & (c) Discuss
- 8. Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the
Options- A. quantity & temperature of waste gas.
- B. dust concentration & nature of dust in waste gas.
- C. corrosive nature of the waste gas.
- D. all (a), (b) and (c). Discuss
- 9. Which of the following is a directly fired intermittant furnace?
Options- A. Walking beam reheating furnace
- B. Reverberatory furnace
- C. Tower furnace
- D. Tunnel kiln Discuss
- 10. Turn down ratio of a burner
Options- A. should be as low as possible i.e., 1 : 2.
- B. should be 1:1 for a batch type furnace..
- C. is the ratio of maximum to minimum permissible heat input rates.
- D. is normally much more for a continuous furnace as compared to a batch furnace. Discuss
Furnace Technology problems
Search Results
Correct Answer: Regenerator
Correct Answer: Both (a) and (b).
Correct Answer: blast furnace gas with air.
Correct Answer: all (a), (b) and (c)
Correct Answer: salt bath furnace.
Correct Answer: all (a), (b) and (c).
Correct Answer: all (a), (b) & (c)
Correct Answer: dust concentration & nature of dust in waste gas.
Correct Answer: Reverberatory furnace
Correct Answer: is the ratio of maximum to minimum permissible heat input rates.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.