Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Specific heating capacity of a furnace is expressed as
Options- A. weight heated/hr
- B. weight heated/furnace volume
- C. weight heated/hr/furnace volume
- D. none of these
- Correct Answer
- weight heated/hr/furnace volume
- 1. Ingress of cold air in the furnaces through cracks, charging doors, openings etc.
Options- A. reduces the flue gas temperature and makes the furnace atmosphere oxidising.
- B. increases the load on the induced draft fan.
- C. reduces the furnace draught.
- D. all (a), (b) and (c) Discuss
- 2. In low or standard frequency induction furnace, heat is produced by the
Options- A. combination of induced current and skin effect.
- B. induction and resistance.
- C. current flow through a heating element.
- D. none of these. Discuss
- 3. Heat transfer rate to the charge/stock in a furnace does not depend upon the
Options- A. type of fuels viz solid, liquid or gaseous.
- B. flue gas temperature.
- C. emissivity of refractory walls.
- D. initial temperature of the charged stock. Discuss
- 4. Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace?
Options- A. Economiser.
- B. Regenerator.
- C. Ceramic recuperator.
- D. Waste heat boiler. Discuss
- 5. Very high pressure boilers are usually __________ boilers.
Options- A. fire tube
- B. water tube
- C. waste heat
- D. natural circulation Discuss
- 6. Heat transfer takes place through a liquid medium surrounding the submerged material under heating, in case of a/an
Options- A. blast furnace.
- B. steam boiler.
- C. salt bath furnace.
- D. annealing furnace. Discuss
- 7. Shaft furnaces are used for
Options- A. smelting
- B. calcining
- C. roasting
- D. all (a), (b) and (c) Discuss
- 8. Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600°C, the percentage stack loss will be maximum in case of complete combustion of
Options- A. furnace oil with air.
- B. furnace oil with oxygen.
- C. blast furnace gas with air.
- D. blast furnace gas with oxygen. Discuss
- 9. Which is a regenerative furnace?
Options- A. Coke oven heating chamber.
- B. Open hearth furnace.
- C. Both (a) and (b).
- D. Neither (a) nor (b). Discuss
- 10. In which of the waste heat recovery equipment, the flow of flue gas and air is alternately reversed after a fixed interval of time?
Options- A. Recuperator
- B. Regenerator
- C. Waste heat boiler
- D. None of these Discuss
Furnace Technology problems
Search Results
Correct Answer: all (a), (b) and (c)
Correct Answer: induction and resistance.
Correct Answer: type of fuels viz solid, liquid or gaseous.
Correct Answer: Regenerator.
Correct Answer: natural circulation
Correct Answer: salt bath furnace.
Correct Answer: all (a), (b) and (c)
Correct Answer: blast furnace gas with air.
Correct Answer: Both (a) and (b).
Correct Answer: Regenerator
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.