Discussion
Home ‣ Chemical Engineering ‣ Furnace Technology Comments
- Question
Very high pressure boilers are usually __________ boilers.
Options- A. fire tube
- B. water tube
- C. waste heat
- D. natural circulation
- Correct Answer
- natural circulation
- 1. Metallic recuperators are not used for waste heat recovery, if the hot flue gas temperature is above __________ °C, because corrosion prevails at higher temperatures.
Options- A. 350
- B. 750
- C. 1050
- D. 1250 Discuss
- 2. Rotary kilns are used in the
Options- A. calcination of limestone & dolomite.
- B. cement manufacture.
- C. both (a) and (b).
- D. neither (a) nor (6). Discuss
- 3. Which of the following accentuates clinker-ing troubles on furnace grate burning coal?
Options- A. Low reactivity of carbonised residue containing high proportion of iron & sulphur.
- B. Low forced draft & fuel bed temperature.
- C. Thick firebed and preheated primary air.
- D. All (a), (b) and (c). Discuss
- 4. An electric furnace producing heat by means of an electric arc struck between each of three electrodes and the charge is called __________ furnace.
Options- A. resistance
- B. arc
- C. low frequency induction
- D. none of these Discuss
- 5. Maximum thermal efficiency of boiler may be about __________ percent.
Options- A. 10
- B. 25
- C. 65
- D. 90 Discuss
- 6. Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace?
Options- A. Economiser.
- B. Regenerator.
- C. Ceramic recuperator.
- D. Waste heat boiler. Discuss
- 7. Heat transfer rate to the charge/stock in a furnace does not depend upon the
Options- A. type of fuels viz solid, liquid or gaseous.
- B. flue gas temperature.
- C. emissivity of refractory walls.
- D. initial temperature of the charged stock. Discuss
- 8. In low or standard frequency induction furnace, heat is produced by the
Options- A. combination of induced current and skin effect.
- B. induction and resistance.
- C. current flow through a heating element.
- D. none of these. Discuss
- 9. Ingress of cold air in the furnaces through cracks, charging doors, openings etc.
Options- A. reduces the flue gas temperature and makes the furnace atmosphere oxidising.
- B. increases the load on the induced draft fan.
- C. reduces the furnace draught.
- D. all (a), (b) and (c) Discuss
- 10. Specific heating capacity of a furnace is expressed as
Options- A. weight heated/hr
- B. weight heated/furnace volume
- C. weight heated/hr/furnace volume
- D. none of these Discuss
Furnace Technology problems
Search Results
Correct Answer: 750
Correct Answer: both (a) and (b).
Correct Answer: All (a), (b) and (c).
Correct Answer: arc
Correct Answer: 90
Correct Answer: Regenerator.
Correct Answer: type of fuels viz solid, liquid or gaseous.
Correct Answer: induction and resistance.
Correct Answer: all (a), (b) and (c)
Correct Answer: weight heated/hr/furnace volume
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.