logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • Maximum differential pressure in liquid manometer is __________ psi.


  • Options
  • A. 20
  • B. 30
  • C. 40
  • D. 50

  • Correct Answer
  • 30 


  • Process Control and Instrumentation problems


    Search Results


    • 1. Phase margin is equal to

    • Options
    • A. 180° - phase lag
    • B. phase lag - 180°
    • C. phase lag + 180°
    • D. phase lag + 90°
    • Discuss
    • 2. Meleoid gauge measures the __________ pressure.

    • Options
    • A. positive
    • B. sub-atmospheric
    • C. very high
    • D. atmospheric
    • Discuss
    • 3. Cascade control means

    • Options
    • A. feed forward control.
    • B. more than one feed-back loop.
    • C. on-off control.
    • D. one feed-back loop.
    • Discuss
    • 4. Which of the following shows maximum dip effect (indicating reverse direction of temperature change)?

    • Options
    • A. Mercury thermometer
    • B. Radiation pyrometer
    • C. Bimetallic thermometer
    • D. Thermocouple
    • Discuss
    • 5. Response of a linear control system for a change in set point is called

    • Options
    • A. frequency response
    • B. transient response
    • C. servo problem
    • D. regulator problem
    • Discuss
    • 6. What is the Laplace transform of impulse input having magnitude 'X'?

    • Options
    • A. X
    • B. X2
    • C. 1/X
    • D. 1
    • Discuss
    • 7. Which of the following is not classified as a thermo electric pyrometer?

    • Options
    • A. Resistance thermometer.
    • B. Thermocouple.
    • C. Optical pyrometer (disappearing filament type)
    • D. Radiation pyrometer
    • Discuss
    • 8. Liquid flow rate in an open channel can not be measured by a/an

    • Options
    • A. orifice meter
    • B. cipolletti weir
    • C. rectangular weir
    • D. V-notch
    • Discuss
    • 9. Water is flowing through a series of four tanks and getting heated as shown in figure. It is desired to design a cascade control scheme for controlling the temperature of water leaving the tank 4 as there is a disturbance in the temperature of a second stream entering the tank 2. Select the best place to take the secondary measurement for the second loop.

    • Options
    • A. Tank 1
    • B. Tank 2
    • C. Tank 3
    • D. Tank 4
    • Discuss
    • 10. Which of the following filled system expansion thermometers has the lowest positive temperature measurement capability?

    • Options
    • A. Mercury in glass thermometer.
    • B. Alcohol in glass thermometer.
    • C. Fused metal (Na or K) in steel thermometer.
    • D. Nitrogen in steel thermometer.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment