logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • Suppose that the gain, time constant and dead time of a process with the following transfer function:Gc(s) = 10 exp( - 0.1s)/(0.5s + 1) are known with a possible error of ± 20% of their values. The largest permissible gain Kc of a proportional controller needs to be calculated below taking the values of process gain, time constant and dead time as


  • Options
  • A. 8, 0.6, 0.08
  • B. 12, 0.6, 0.12
  • C. 8, 0.6, 0.12
  • D. 12, 0.4, 0.08

  • Correct Answer
  • 12, 0.6, 0.12 


  • Process Control and Instrumentation problems


    Search Results


    • 1. A bimetallic thermometer as compared to industrial mercury in glass thermometer has almost the same

    • Options
    • A. temperature measuring range (- 40°C to 450°C).
    • B. accuracy (± 1% of span).
    • C. speed of response.
    • D. all a, b & c.
    • Discuss
    • 2. Gas analysis is commonly done using the

    • Options
    • A. thermal conductivity cell
    • B. X-ray diffraction
    • C. mass spectrometer
    • D. emission spectrometer
    • Discuss
    • 3. The transfer function of a pure dead time system with dead time ?d is

    • Options
    • A. 1/(?ds + 1)
    • B. ?ds + 1
    • C. e-?ss
    • D. e?ds
    • Discuss
    • 4. Process degree of freedom indicates __________ number of controllers to be used.

    • Options
    • A. the maximum
    • B. the minimum
    • C. both maximum and the minimum
    • D. nothing about the
    • Discuss
    • 5. Liquid levels in autocalves are measued by

    • Options
    • A. simple float
    • B. differential float type manometer
    • C. glass gauge
    • D. none of these
    • Discuss
    • 6. For a feed back control system to be stable, the

    • Options
    • A. roots of the characteristic equation should be real.
    • B. poles of the closed loop transfer function should lie in the left half of the complex plane.
    • C. Bode plots of the corresponding open loop transfer function should monotoni-cally decrease.
    • D. poles of the closed loop transfer function should lie in the right half of the complex plane.
    • Discuss
    • 7. __________ controller has the maximum stabilising time.

    • Options
    • A. P
    • B. PD
    • C. PI
    • D. PID
    • Discuss
    • 8. __________ type of element is normally not used in the bimetallic thermometers.

    • Options
    • A. Flat spiral
    • B. Bourdon tube
    • C. Single helix
    • D. Multiple helix
    • Discuss
    • 9. Flow rate of sludge is not measured by a/an

    • Options
    • A. orificemeter
    • B. open weir
    • C. kennison nozzle
    • D. both(b)&(c)
    • Discuss
    • 10. Which of the following is not a second order instrument?

    • Options
    • A. Mercury in glass thermometer with covering.
    • B. Bare mercury in glass thermometer.
    • C. Pressure gauge with one bellow, two tubes and a tank.
    • D. None of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment