logo

CuriousTab

CuriousTab

Discussion

Home ‣ Chemical Engineering ‣ Process Control and Instrumentation Comments
  • Question

  • Dilatometer is used to measure


  • Options
  • A. stress
  • B. strain
  • C. deflection
  • D. contraction/expansion due to changes in temperature

  • Correct Answer
  • contraction/expansion due to changes in temperature 

    • Process Control and Instrumentation problems

    Search Results

    • 1. The inverse Laplace transform of the function is

    • Options
    • A. 1 + et
    • B. 1 - et
    • C. 1 + e-t
    • D. 1 - e-t
      • Discuss
    • 2. Helium gas constant volume thermometer is suitable for the measurement of a temperature of __________ °C.

    • Options
    • A. < 100
    • B. < 0
    • C. > 0
    • D. > 800
      • Discuss
    • 3. The offset introduced by proportional controller with gain Kcin response of first order system can be reduced by

    • Options
    • A. reducing value of Kc.
    • B. introducing integral control.
    • C. introducing derivative control.
    • D. none of the above.
      • Discuss
    • 4. In an exothermic chemical reactor, the manipulated variable is the flow rate of

    • Options
    • A. coolant
    • B. reactants
    • C. product
    • D. none of these
      • Discuss
    • 5. In a second order under damped system, the

    • Options
    • A. time required for the response of first reach its ultimate value is called the response time.
    • B. overshoot (which is a measure of how much the response exceeds the ultimate value) increase with the decrease of damping co-efficient e.
    • C. decay ratio (which is the ratio of the sizes of successive peaks) is equal to the reciprocal of overshoot.
    • D. characteristics of a step response is represented by
      • Discuss
    • 6. The transfer function of a first order system is

    • Options
    • A.
    • B.
    • C.
    • D. none of these
      • Discuss
    • 7. Optical activity of a solution can be determined using a

    • Options
    • A. polarimeter
    • B. polarograph
    • C. dilatometer
    • D. refractrometer
      • Discuss
    • 8. Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as :

    • Options
    • A. Q0(T0 - T) = Ac .
    • B. Q0T0 - QT = Ac .
    • C. Q(T0 - T) = Ac .
    • D. Q(T0 - T) = Ac .
      • Discuss
    • 9. __________ stability method uses open loop transfer function.

    • Options
    • A. Nyquist
    • B. Mikhalov
    • C. Ruth
    • D. none of these
      • Discuss
    • 10. Thermal conductivity based continuous flue gas analyser makes use of varying thermal conductivity of the constituents of flue gases. Which of the following constituents of flue gases has the maximum thermal conductivity?

    • Options
    • A. CO2
    • B. N2
    • C. O2
    • D. CO
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.