logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • All the thermocouples used for temperature measurement use dissimilar metal


  • Options
  • A. strips
  • B. bars
  • C. wires
  • D. beads

  • Correct Answer
  • wires 


  • Process Control and Instrumentation problems


    Search Results


    • 1. Bourdon gauges are used for measuring pressure (kg/cm2 )

    • Options
    • A. < atmospheric
    • B. > 2 (gauge)
    • C. < 2 (gauge)
    • D. > 10 (absolute)
    • Discuss
    • 2. Mercury thermometer can be used to measure the temperature upto __________ °C.

    • Options
    • A. 100
    • B. 250
    • C. 350
    • D. 750
    • Discuss
    • 3. Very low pressure is expressed in microns(?), which is equal to __________ mm of Hg coloumn (absolute) at 0°C.

    • Options
    • A. 0.0001
    • B. 0.001
    • C. 0.01
    • D. 0.1
    • Discuss
    • 4. Working principle of mercury in glass thermometer is based on volumetric expansion of mercury with increase in temperature. Which of the following undergoes minimum volumetric expansion for a given temperature change?

    • Options
    • A. Water
    • B. Mercury
    • C. Methyl alcohal
    • D. Carbon-tetrachloride
    • Discuss
    • 5. Which of the following does not figure in the list of seven substances selected for international temperature scale?

    • Options
    • A. Ice (F.P) and steam (B.P)
    • B. Oxygen and sulphur (B.P)
    • C. Antimony and silver (F.P)
    • D. Zinc (B.P) and mercury (F.P)
    • Discuss
    • 6. The time constant of a unity gain, first order plus time delay process is 5 min. If the phase lag at a frequency of 0.2 rad/min is 60°, then the dead time (in minutes) is

    • Options
    • A. 5?/12
    • B. ?/6
    • C. ?/12
    • D. ?/3
    • Discuss
    • 7. In a second order under damped system, the

    • Options
    • A. time required for the response of first reach its ultimate value is called the response time.
    • B. overshoot (which is a measure of how much the response exceeds the ultimate value) increase with the decrease of damping co-efficient e.
    • C. decay ratio (which is the ratio of the sizes of successive peaks) is equal to the reciprocal of overshoot.
    • D. characteristics of a step response is represented by
    • Discuss
    • 8. In an exothermic chemical reactor, the manipulated variable is the flow rate of

    • Options
    • A. coolant
    • B. reactants
    • C. product
    • D. none of these
    • Discuss
    • 9. The offset introduced by proportional controller with gain Kcin response of first order system can be reduced by

    • Options
    • A. reducing value of Kc.
    • B. introducing integral control.
    • C. introducing derivative control.
    • D. none of the above.
    • Discuss
    • 10. Helium gas constant volume thermometer is suitable for the measurement of a temperature of __________ °C.

    • Options
    • A. < 100
    • B. < 0
    • C. > 0
    • D. > 800
    • Discuss


    Comments

    There are no comments.

Enter a new Comment