logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The element exhibits a negative phase shift at all frequencies. The absolute value of the phase shift increases linearly with frequency. The element has the transfer function


  • Options
  • A. e-?s
  • B. The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The
  • C. The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The
  • D. The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The

  • Correct Answer
  • e-?s 


  • Process Control and Instrumentation problems


    Search Results


    • 1. Liquid discharge from a tank or reservoir can not be measured by

    • Options
    • A. orificemeters
    • B. weirs
    • C. mouthpieces
    • D. notches
    • Discuss
    • 2. The transfer function for a first order process with time delay is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. Use of I-control along with P-control facilitates

    • Options
    • A. elimination of offset
    • B. reduction of offset
    • C. reduction of stability time
    • D. none of these
    • Discuss
    • 4. Which of the systems having the following transfer function is stable?

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 5. Turbine flow meters are suitable for

    • Options
    • A. very limited flow ranges.
    • B. cryogenic flow measurements.
    • C. aerospace and in air borne applications.
    • D. both (b) and (c).
    • Discuss
    • 6. A mercury barometer measures the __________ pressure.

    • Options
    • A. atmospheric
    • B. gauge
    • C. vacuum
    • D. absolute
    • Discuss
    • 7. __________ are analysed using a polarograph.

    • Options
    • A. Isotonic solutions
    • B. Solids
    • C. Liquids
    • D. Gases
    • Discuss
    • 8. Measurement of sub-zero Celcius temperature in industry is done most commonly by

    • Options
    • A. thermocouples
    • B. resistance thermometers
    • C. gas thermometers
    • D. bi-metallic thermometers
    • Discuss
    • 9. Which of the following is not a mechanical pressure sensing element?

    • Options
    • A. Bellows
    • B. Diaphragm
    • C. Bourdon tube
    • D. U-tube
    • Discuss
    • 10. Pirani gauge is used for the measurement of

    • Options
    • A. very high pressure.
    • B. high vacuum.
    • C. liquid level under pressure.
    • D. liquid level at atmospheric pressure
    • Discuss


    Comments

    There are no comments.

Enter a new Comment