logo

CuriousTab

CuriousTab

Discussion

Home ‣ Chemical Engineering ‣ Process Control and Instrumentation Comments
  • Question

  • Liquid discharge from a tank or reservoir can not be measured by


  • Options
  • A. orificemeters
  • B. weirs
  • C. mouthpieces
  • D. notches

  • Correct Answer
  • orificemeters 

    • Process Control and Instrumentation problems

    Search Results

    • 1. The transfer function for a first order process with time delay is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 2. Use of I-control along with P-control facilitates

    • Options
    • A. elimination of offset
    • B. reduction of offset
    • C. reduction of stability time
    • D. none of these
      • Discuss
    • 3. Which of the systems having the following transfer function is stable?

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 4. Turbine flow meters are suitable for

    • Options
    • A. very limited flow ranges.
    • B. cryogenic flow measurements.
    • C. aerospace and in air borne applications.
    • D. both (b) and (c).
      • Discuss
    • 5. The calibration data of a thermocouple with its cold junction at 0°C are given below.

      The hot junction of the thermocouple is placed in a bath at 80°C, while its cold junction is at 20°C. What is the emf of thermocouple?

    • Options
    • A. 3.26 mv
    • B. 0.80 mv
    • C. 2.46 mv
    • D. 2.43 mv
      • Discuss
    • 6. The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The element exhibits a negative phase shift at all frequencies. The absolute value of the phase shift increases linearly with frequency. The element has the transfer function

    • Options
    • A. e-?s
    • B.
    • C.
    • D.
      • Discuss
    • 7. A mercury barometer measures the __________ pressure.

    • Options
    • A. atmospheric
    • B. gauge
    • C. vacuum
    • D. absolute
      • Discuss
    • 8. __________ are analysed using a polarograph.

    • Options
    • A. Isotonic solutions
    • B. Solids
    • C. Liquids
    • D. Gases
      • Discuss
    • 9. Measurement of sub-zero Celcius temperature in industry is done most commonly by

    • Options
    • A. thermocouples
    • B. resistance thermometers
    • C. gas thermometers
    • D. bi-metallic thermometers
      • Discuss
    • 10. Which of the following is not a mechanical pressure sensing element?

    • Options
    • A. Bellows
    • B. Diaphragm
    • C. Bourdon tube
    • D. U-tube
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.