logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • Magnetic flowmeters are generally not used for the velocity/flow measurement of hydrocarbons due to their


  • Options
  • A. low thermal conductivity.
  • B. low electrical conductivity.
  • C. high viscosity index.
  • D. low flash point.

  • Correct Answer
  • low electrical conductivity. 


  • Process Control and Instrumentation problems


    Search Results


    • 1. Starting temperature of optical radiation pyrometer is __________ °C.

    • Options
    • A. 800
    • B. 400
    • C. 1200
    • D. 1500
    • Discuss
    • 2. Liquid argon level in a pressurised storage tank (at 3 kg/cm2 ) is measured by a/an

    • Options
    • A. gage glass
    • B. external float gage
    • C. differential pressure gage
    • D. none of these
    • Discuss
    • 3. Which of the following controllers has maximum offset?

    • Options
    • A. P-controller
    • B. P-I controller
    • C. P-D controller
    • D. P-I-D controller
    • Discuss
    • 4. The amplitude ratio for the sinusoidal response of __________ is < 1.

    • Options
    • A. transportation lag
    • B. first order system
    • C. second order system
    • D. none of these
    • Discuss
    • 5. __________ thermometer can not measure sub-zero (< 0° C) temperature,

    • Options
    • A. Mercury in glass
    • B. Bimetallic
    • C. Vapor pressure
    • D. Resistance
    • Discuss
    • 6. The calibration data of a thermocouple with its cold junction at 0°C are given below.

      The hot junction of the thermocouple is placed in a bath at 80°C, while its cold junction is at 20°C. What is the emf of thermocouple?

    • Options
    • A. 3.26 mv
    • B. 0.80 mv
    • C. 2.46 mv
    • D. 2.43 mv
    • Discuss
    • 7. Turbine flow meters are suitable for

    • Options
    • A. very limited flow ranges.
    • B. cryogenic flow measurements.
    • C. aerospace and in air borne applications.
    • D. both (b) and (c).
    • Discuss
    • 8. Which of the systems having the following transfer function is stable?

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 9. Use of I-control along with P-control facilitates

    • Options
    • A. elimination of offset
    • B. reduction of offset
    • C. reduction of stability time
    • D. none of these
    • Discuss
    • 10. The transfer function for a first order process with time delay is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment