logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • The deflection of the free end of the bimetallic strips in a bimetallic thermometer with temperature is nearly


  • Options
  • A. linear
  • B. non-linear
  • C. parabolic
  • D. hyperbolic

  • Correct Answer
  • linear 


  • Process Control and Instrumentation problems


    Search Results


    • 1. Which of the following is not a speed measuring instrument?

    • Options
    • A. Psychrometer
    • B. Stroboscope
    • C. Tachometer
    • D. All (a), (b) and (c)
    • Discuss
    • 2. An amplitude ratio of 0.1 corresponds to __________ decibels.

    • Options
    • A. 20
    • B. -20
    • C. 10
    • D. -10
    • Discuss
    • 3. The response of two tanks of same size and resistance in series is

    • Options
    • A. under damped
    • B. critically damped
    • C. over damped
    • D. none of the above
    • Discuss
    • 4. The __________ of the fluid contained in the temperature sensing element (i.e., bulb) of filled system thermometers changes with change in temperature.

    • Options
    • A. pressure
    • B. volume
    • C. viscosity
    • D. all (a), (b) and (c)
    • Discuss
    • 5. Continuous measurement of moisture in paper is done by

    • Options
    • A. sling psychrometer.
    • B. hair-hygrometer.
    • C. weighing.
    • D. high resistance Wheatstone's bridge circuit.
    • Discuss
    • 6. The term analogous to the electrical current in a thermal system is the

    • Options
    • A. temperature difference
    • B. heat flow rate
    • C. heat content in the system
    • D. none of these
    • Discuss
    • 7. The unit step response of the transfer functionreaches its final steady state assymptotically after

    • Options
    • A. a monotonic increase.
    • B. a monotonic decrease.
    • C. initially increasing and then decreasing.
    • D. increasing decreasing and then increasing.
    • Discuss
    • 8. Positioning controllers are used for

    • Options
    • A. low loads
    • B. temperature changes
    • C. high loads
    • D. flow rate changes
    • Discuss
    • 9. Which of the following judges the accuracy of an instrument?

    • Options
    • A. Dead zone
    • B. Drift
    • C. Static error
    • D. None of these
    • Discuss
    • 10. The amplitude ratio for the sinusoidal response of a __________ is 1.

    • Options
    • A. first order system
    • B. second order system
    • C. transportation lag
    • D. none of these
    • Discuss


    Comments

    There are no comments.

Enter a new Comment