logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Process Control and Instrumentation Comments

  • Question
  • An ideal PID controller has the transfer function An ideal PID controller has the transfer function . The frequency at which the magnitude ratio of th. The frequency at which the magnitude ratio of the controller is 1, is


  • Options
  • A. 0.5/0.2
  • B. 0.2/0.5
  • C. 0.2 x 0.5
  • D. 1/0.2 x 0.5

  • Correct Answer
  • 1/0.2 x 0.5 


  • Process Control and Instrumentation problems


    Search Results


    • 1. For the block diagram shown below :

      The characteristic equation is

    • Options
    • A. ?l S (?ps + 1) + Kc . Kp (?lS + 1) e-?d s = 0
    • B. (?mS + 1) (?pS + 1) + Km . Kp e-?d S = 0
    • C. ?l S(?m S + 1) (?p S + 1) +Kc . Kp . Km (?l s + 1) e-?dS = 0
    • D. (?ms + 1) (?p s + 1) + Kc . Kp . Km . e-?dS = 0
    • Discuss
    • 2. Pressure of 0.0001 absolute psi can be measured by __________ gauge.

    • Options
    • A. Mcloid
    • B. Pirani
    • C. thermocouple
    • D. none of these
    • Discuss
    • 3. For increased speed of response of an expansion pressure spring thermometer, the thermometer bulb should have a

    • Options
    • A. large area but small mass.
    • B. high thermal conductivity.
    • C. small specific heat.
    • D. all'a', 'b' & 'c'.
    • Discuss
    • 4. Pressure of 0.01 psi (absolute) can be measured by __________ gauge.

    • Options
    • A. ionisation
    • B. Pirani
    • C. Mcloid
    • D. none of these
    • Discuss
    • 5. On-off controllers are normally used for

    • Options
    • A. low loads
    • B. temperature changes
    • C. flow rate changes
    • D. none of these
    • Discuss
    • 6. Continuous measurement of moisture in paper is done by

    • Options
    • A. sling psychrometer.
    • B. hair-hygrometer.
    • C. weighing.
    • D. high resistance Wheatstone's bridge circuit.
    • Discuss
    • 7. The __________ of the fluid contained in the temperature sensing element (i.e., bulb) of filled system thermometers changes with change in temperature.

    • Options
    • A. pressure
    • B. volume
    • C. viscosity
    • D. all (a), (b) and (c)
    • Discuss
    • 8. The response of two tanks of same size and resistance in series is

    • Options
    • A. under damped
    • B. critically damped
    • C. over damped
    • D. none of the above
    • Discuss
    • 9. An amplitude ratio of 0.1 corresponds to __________ decibels.

    • Options
    • A. 20
    • B. -20
    • C. 10
    • D. -10
    • Discuss
    • 10. Which of the following is not a speed measuring instrument?

    • Options
    • A. Psychrometer
    • B. Stroboscope
    • C. Tachometer
    • D. All (a), (b) and (c)
    • Discuss


    Comments

    There are no comments.

Enter a new Comment