logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Petroleum Refinery Engineering Comments

  • Question
  • Visbreaking


  • Options
  • A. uses natural gas as feed.
  • B. is carried out at atmospheric pressure.
  • C. produces fuel oil of lower viscosity.
  • D. produces gasoline only.

  • Correct Answer
  • produces fuel oil of lower viscosity. 


  • Petroleum Refinery Engineering problems


    Search Results


    • 1. Which of the following processes is used for the production of petroleum coke?

    • Options
    • A. Stabilisation
    • B. Visbreaking
    • C. Cracking
    • D. Reforming
    • Discuss
    • 2. Octane number (unleaded) of gasoline produced by isomerisation of butane may be about

    • Options
    • A. 45
    • B. 55
    • C. 70
    • D. 90
    • Discuss
    • 3. Feedstock for polymerisation is

    • Options
    • A. naphtha.
    • B. cracked gases rich in C2 & C4 olefins.
    • C. low boiling aromatics.
    • D. none of these.
    • Discuss
    • 4. The amount of tetraethyl lead added to improve the octane number of motor gasoline is around __________ c.c per gallon of petrol.

    • Options
    • A. 3
    • B. 300
    • C. 3000
    • D. 1000
    • Discuss
    • 5. Hydrogen percentage (by weight) in crude petroleum may be about

    • Options
    • A. 5
    • B. 15
    • C. 25
    • D. 35
    • Discuss
    • 6. In a refinery petroleum crude is fractionated into gas fraction, light ends, intermediate distillates, heavy distillates, residues and by products. The group of products including gas oil, diesel oil and heavy fuel oil belongs to the fraction

    • Options
    • A. heavy distillates
    • B. intermediate distillates
    • C. light ends
    • D. residues
    • Discuss
    • 7. Humidity of air can be determined by a

    • Options
    • A. chromatograph
    • B. sling psychrometer
    • C. mass spectrometer
    • D. polarimeter
    • Discuss
    • 8. Concentration of sugar solution can be determined by the

    • Options
    • A. polarimetry
    • B. flame photometry
    • C. emission spectroscopy
    • D. oscillometry
    • Discuss
    • 9. Nitrogen gas constant volume thermometer is suitable for measuring a temperature of __________ °C.

    • Options
    • A. 0-100
    • B. < 0
    • C. > 100.
    • D. > 50
    • Discuss
    • 10. Strain gage uses an electrical conductor wire, which when elastically stretched increases in length and reduces in diameter. Both these dimensional changes result in __________ in the electrical resistance of the wire.

    • Options
    • A. no change
    • B. decrease
    • C. increase
    • D. exponential decrease
    • Discuss


    Comments

    There are no comments.

Enter a new Comment