Discussion
Home ‣ Chemical Engineering ‣ Petroleum Refinery Engineering Comments
- Question
Name the endothermic reaction out of the following:
Options- A. Catalytic cracking.
- B. Hydrocracking.
- C. Dehydrogeneration of naphthene to produce aromatic.
- D. Catalytic polymerisation.
- Correct Answer
- Dehydrogeneration of naphthene to produce aromatic.
- 1. Mercapsol and Unisol processes are meant for the
Options- A. dearomatisation of kerosene
- B. removal of mercaptans
- C. dewaxing
- D. decoloration Discuss
- 2. Solvent used in Edeleanu process is
Options- A. furfural
- B. propane
- C. liquid SO2
- D. phenol Discuss
- 3. In solutizer sweetening process, solutizer solution used is
Options- A. methanol in Unisol process.
- B. naphthenic acid in Mercapsol process.
- C. both (a) and (b).
- D. neither (a) nor (b). Discuss
- 4. Pick out the correct statement about catalytic polymerisation.
Options- A. H2SO4 polymerisation process gives gasoline rich in unsaturates.
- B. In H2SO4 polymerisation, H3PO4 is always used with 2% steam to prevent meta & ortho H3PO4 formation, which are inactive.
- C. both (a) and (b)
- D. neither (a) nor (b) Discuss
- 5. Which one is preferred for aircraft engine?
Options- A. High viscosity index lube oil.
- B. Low viscosity index lube oil.
- C. High freezing point aviation fuel.
- D. None of these. Discuss
- 6. Both asphalt and wax are produced by __________ base crude oils.
Options- A. naphthenic
- B. asphalt
- C. paraffin
- D. mixed Discuss
- 7. Petroleum coke is commercially produced by the __________ process.
Options- A. hydrocracking
- B. visbreaking
- C. fluid catalytic cracking
- D. delayed coking Discuss
- 8. High aniline point of diesel indicates that, it
Options- A. is highly aromatic.
- B. has a large ignition delay.
- C. is highly paraffinic.
- D. has a low diesel index. Discuss
- 9. Which one of the following processes aims at producing higher yield of gaseous unsaturated hydrocarbons and aromatics like benzene & toluene?
Options- A. Reforming
- B. Pyrolysis
- C. Alkylation
- D. Hydrocracking Discuss
- 10. Catalyst used in the isomerisation is
Options- A. aluminium chloride
- B. alumina
- C. nickel
- D. phosphoric acid Discuss
Petroleum Refinery Engineering problems
Search Results
Correct Answer: removal of mercaptans
Correct Answer: liquid SO2
Correct Answer: both (a) and (b).
Correct Answer: In H2SO4 polymerisation, H3PO4 is always used with 2% steam to prevent meta & ortho H3PO4 formation, which are inactive.
Correct Answer: High viscosity index lube oil.
Correct Answer: mixed
Correct Answer: delayed coking
Correct Answer: is highly paraffinic.
Correct Answer: Reforming
Correct Answer: aluminium chloride
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.