logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Petroleum Refinery Engineering Comments

  • Question
  • Clay treatment is used to remove


  • Options
  • A. salt from the crude oil.
  • B. colour & dissolved gases from cracked gasoline.
  • C. wax from lube oil.
  • D. none of these.

  • Correct Answer
  • colour & dissolved gases from cracked gasoline. 


  • Petroleum Refinery Engineering problems


    Search Results


    • 1. Cetane number of a diesel fuel is the measure of its

    • Options
    • A. ignition delay
    • B. smoke point
    • C. viscosity
    • D. oxidation stability
    • Discuss
    • 2. The vacuum maintained in vacuum distillation unit for reduced crude is about __________ mmHg.

    • Options
    • A. 1.2
    • B. 12
    • C. 120
    • D. 700
    • Discuss
    • 3. The most suitable solvent for deasphalting vacuum residue is

    • Options
    • A. propane
    • B. methyl ethyl ketone
    • C. doctor's solution
    • D. methanol amine
    • Discuss
    • 4. Pressure & temperature maintained in catalytic cracking is about

    • Options
    • A. 2atm & 500°C
    • B. 10atm & 500°C
    • C. 30atm & 200°C
    • D. 50atm. & 750°C
    • Discuss
    • 5. Highest quality bitumen is produced from the __________ crude oil.

    • Options
    • A. paraffinic
    • B. naphthenic
    • C. intermediate
    • D. mixed
    • Discuss
    • 6. Pick out the wrong statement.

    • Options
    • A. Pensky-Marten apparatus is used for determining flash points above 50°C.
    • B. Characterisation factor of paraffinic crude oil is more than 12.
    • C. Abel apparatus is used for determining flash points below 50°C.
    • D. An oil having high susceptibility to change in viscosity with temperature changes, has a high viscosity index.
    • Discuss
    • 7. 1 centistoke is equal to __________ Redwood I seconds.

    • Options
    • A. 1
    • B. 4.08
    • C. 0.408
    • D. 40.8
    • Discuss
    • 8. Gasoline yield in catalytic reforming of naphtha may be about __________ percent by weight.

    • Options
    • A. 85
    • B. 65
    • C. 50
    • D. 98
    • Discuss
    • 9. Aniline point of high speed diesel may be about __________ °C.

    • Options
    • A. 35
    • B. 70
    • C. 105
    • D. 150
    • Discuss
    • 10. Which of the following does not require preheating during storage in the storage tank as well as during atomisation through burners?

    • Options
    • A. PCM
    • B. Tar
    • C. Light diesel oil
    • D. Low viscosity furnace oil
    • Discuss


    Comments

    There are no comments.

Enter a new Comment