logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Petroleum Refinery Engineering Comments

  • Question
  • With increase in the molecular weight of aromatic present in kerosene, its smoking tendency


  • Options
  • A. increases
  • B. decreases
  • C. remains same
  • D. is unpredictable

  • Correct Answer
  • increases 


  • Petroleum Refinery Engineering problems


    Search Results


    • 1. Paraffins are desirable in lubricating oil, as it has got high

    • Options
    • A. viscosity
    • B. viscosity index
    • C. smoke point
    • D. pour point
    • Discuss
    • 2. Waxes present in petroleum products

    • Options
    • A. can be separated out by distillation.
    • B. are not soluble in them.
    • C. crystallise out at low temperature.
    • D. decrease their viscosity.
    • Discuss
    • 3. Feed for reforming is generally

    • Options
    • A. naphtha or straight run gasoline.
    • B. reduced crude.
    • C. vacuum gas oil.
    • D. atmospheric gas oil.
    • Discuss
    • 4. Cracking is

    • Options
    • A. an exothermic reaction.
    • B. an endothermic reaction.
    • C. favoured at very low temperature.
    • D. none of these.
    • Discuss
    • 5. Which of the following is not an important property of fuel oil/furnace oil?

    • Options
    • A. Sulphur content
    • B. Viscosity
    • C. Aniline point
    • D. Flash point
    • Discuss
    • 6. Water separometer index (modified) (WSIM) of a petrofuel is the measure of its

    • Options
    • A. emulsification tendency.
    • B. water separation characteristics.
    • C. water content.
    • D. water absorbing capacity from atmosphere.
    • Discuss
    • 7. Good quality kerosene should have

    • Options
    • A. low smoke point.
    • B. high smoke point.
    • C. high aromatics content.
    • D. low paraffins content.
    • Discuss
    • 8. Which of the following has the lowest cetane number?

    • Options
    • A. Aromatics
    • B. i-paraffins
    • C. Naphthene
    • D. Olefins
    • E. n-paraffins
    • Discuss
    • 9. Highest quality bitumen is produced from the __________ crude oil.

    • Options
    • A. paraffinic
    • B. naphthenic
    • C. intermediate
    • D. mixed
    • Discuss
    • 10. Pressure & temperature maintained in catalytic cracking is about

    • Options
    • A. 2atm & 500°C
    • B. 10atm & 500°C
    • C. 30atm & 200°C
    • D. 50atm. & 750°C
    • Discuss


    Comments

    There are no comments.

Enter a new Comment