logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Petroleum Refinery Engineering Comments

  • Question
  • Cracking is


  • Options
  • A. an exothermic reaction.
  • B. an endothermic reaction.
  • C. favoured at very low temperature.
  • D. none of these.

  • Correct Answer
  • an endothermic reaction. 


  • Petroleum Refinery Engineering problems


    Search Results


    • 1. Which of the following is not an important property of fuel oil/furnace oil?

    • Options
    • A. Sulphur content
    • B. Viscosity
    • C. Aniline point
    • D. Flash point
    • Discuss
    • 2. A fuel oil consists of 4 fractions A, B, C and D. Their molar compositions and vapour pressures are given below :

      The vapour pressure of the fuel oil will be __________ mm Hg.

    • Options
    • A. 736
    • B. 727.5
    • C. 512
    • D. 767.8
    • Discuss
    • 3. Which of the following is a non-regenerative fixed bed catalytic reforming process?

    • Options
    • A. Hydroforming
    • B. Thermofer catalytic reforming
    • C. Platforming
    • D. Hyperforming
    • Discuss
    • 4. Maximum viscosity of tar/PCM/fuel oil for easy and efficient atomisation in conventional burner is __________ centistokes (or 100 Redwood I seconds).

    • Options
    • A. 5
    • B. 25
    • C. 50
    • D. 100
    • Discuss
    • 5. Extractor temperature is maintained at -20°C in Edeleanu process to reduce the __________ of kerosene.

    • Options
    • A. smoke point
    • B. paraffins
    • C. aromatics
    • D. naphthenes
    • Discuss
    • 6. Feed for reforming is generally

    • Options
    • A. naphtha or straight run gasoline.
    • B. reduced crude.
    • C. vacuum gas oil.
    • D. atmospheric gas oil.
    • Discuss
    • 7. Waxes present in petroleum products

    • Options
    • A. can be separated out by distillation.
    • B. are not soluble in them.
    • C. crystallise out at low temperature.
    • D. decrease their viscosity.
    • Discuss
    • 8. Paraffins are desirable in lubricating oil, as it has got high

    • Options
    • A. viscosity
    • B. viscosity index
    • C. smoke point
    • D. pour point
    • Discuss
    • 9. With increase in the molecular weight of aromatic present in kerosene, its smoking tendency

    • Options
    • A. increases
    • B. decreases
    • C. remains same
    • D. is unpredictable
    • Discuss
    • 10. Water separometer index (modified) (WSIM) of a petrofuel is the measure of its

    • Options
    • A. emulsification tendency.
    • B. water separation characteristics.
    • C. water content.
    • D. water absorbing capacity from atmosphere.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment