logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Petroleum Refinery Engineering Comments

  • Question
  • Which of the following is a non-regenerative fixed bed catalytic reforming process?


  • Options
  • A. Hydroforming
  • B. Thermofer catalytic reforming
  • C. Platforming
  • D. Hyperforming

  • Correct Answer
  • Platforming 


  • Petroleum Refinery Engineering problems


    Search Results


    • 1. Maximum viscosity of tar/PCM/fuel oil for easy and efficient atomisation in conventional burner is __________ centistokes (or 100 Redwood I seconds).

    • Options
    • A. 5
    • B. 25
    • C. 50
    • D. 100
    • Discuss
    • 2. Extractor temperature is maintained at -20°C in Edeleanu process to reduce the __________ of kerosene.

    • Options
    • A. smoke point
    • B. paraffins
    • C. aromatics
    • D. naphthenes
    • Discuss
    • 3. Which of the following has the minimum °API gravity of all?

    • Options
    • A. Diesel
    • B. Kerosene
    • C. Petrol
    • D. Furnace oil
    • Discuss
    • 4. Thermofer catalytic cracking process is a __________ process.

    • Options
    • A. fixed bed
    • B. moving bed
    • C. fluidised bed
    • D. non-catalytic
    • Discuss
    • 5. The main reaction in reforming is the

    • Options
    • A. dehydrogenation of naphthenes.
    • B. hydrogenation of naphthenes.
    • C. hydrocracking of paraffins.
    • D. saturation of olefins.
    • Discuss
    • 6. A fuel oil consists of 4 fractions A, B, C and D. Their molar compositions and vapour pressures are given below :

      The vapour pressure of the fuel oil will be __________ mm Hg.

    • Options
    • A. 736
    • B. 727.5
    • C. 512
    • D. 767.8
    • Discuss
    • 7. Which of the following is not an important property of fuel oil/furnace oil?

    • Options
    • A. Sulphur content
    • B. Viscosity
    • C. Aniline point
    • D. Flash point
    • Discuss
    • 8. Cracking is

    • Options
    • A. an exothermic reaction.
    • B. an endothermic reaction.
    • C. favoured at very low temperature.
    • D. none of these.
    • Discuss
    • 9. Feed for reforming is generally

    • Options
    • A. naphtha or straight run gasoline.
    • B. reduced crude.
    • C. vacuum gas oil.
    • D. atmospheric gas oil.
    • Discuss
    • 10. Waxes present in petroleum products

    • Options
    • A. can be separated out by distillation.
    • B. are not soluble in them.
    • C. crystallise out at low temperature.
    • D. decrease their viscosity.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment