Discussion
Home ‣ Chemical Engineering ‣ Petroleum Refinery Engineering Comments
- Question
Char value of Kerosene is the amount of charred oil deposition on the wick obtained after burning it in a standard wick lamp at a standard rate for 24 hours. Char value of a good quality kerosene should be less than __________ mg/kg of kerosene.
Options- A. 1
- B. 20
- C. 100
- D. 500
- Correct Answer
- 20
- 1. Products drawn from the top to bottom of the crude oil distillation column has progressively increasing
Options- A. boiling points
- B. molecular weight
- C. C/H ratio
- D. all (a), (b) and (c) Discuss
- 2. Salt content (measured as sodium chloride) in electrically desalted crude oil comes down to a level of about __________ ptb (pounds per thousand barrel).
Options- A. 0.03
- B. 3
- C. 35
- D. 70 Discuss
- 3. Asphalts are
Options- A. low molecular weight & low boiling point compounds present in petroleum.
- B. desirable in catalytic cracking feedstock, because they produce coke.
- C. readily oxidisable and form carbonaceous sludge.
- D. all (a), (b) & (c). Discuss
- 4. Which of the following gasolines (unleaded) has the least octane number?
Options- A. Catalytically cracked gasoline
- B. Straight run gasoline
- C. Catalytically reformed gasoline
- D. Polymer gasoline Discuss
- 5. Tetraethyl lead is added to the petrol to increase its octane number, because its octane number is
Options- A. more than 100
- B. round about 100
- C. between 50 and 100
- D. less than 25 Discuss
- 6. Which of the following is the most important property for a jet fuel?
Options- A. Cloud point
- B. Pour point
- C. Colour
- D. Freezing point Discuss
- 7. The most important property for a jet fuel is its
Options- A. viscosity
- B. freezing point
- C. calorific value
- D. flash point Discuss
- 8. Which of the following reactions is undesirable in the production of catalytically reformed gasoline?
Options- A. Dehydrogenation of naphthene
- B. Dehydrogenation of lower paraffins
- C. Dehydrocyclisation of higher paraffins
- D. Isomerisation of paraffins Discuss
- 9. The main reaction in reforming is the
Options- A. dehydrogenation of naphthenes.
- B. hydrogenation of naphthenes.
- C. hydrocracking of paraffins.
- D. saturation of olefins. Discuss
- 10. Thermofer catalytic cracking process is a __________ process.
Options- A. fixed bed
- B. moving bed
- C. fluidised bed
- D. non-catalytic Discuss
Petroleum Refinery Engineering problems
Search Results
Correct Answer: all (a), (b) and (c)
Correct Answer: 3
Correct Answer: readily oxidisable and form carbonaceous sludge.
Correct Answer: Straight run gasoline
Correct Answer: more than 100
Correct Answer: Freezing point
Correct Answer: freezing point
Correct Answer: Dehydrogenation of lower paraffins
Correct Answer: dehydrogenation of naphthenes.
Correct Answer: non-catalytic
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.