Discussion
Home ‣ Chemical Engineering ‣ Petroleum Refinery Engineering Comments
- Question
Operating temperature and pressure in catalytic reforming is about
Options- A. 1-5 Kgf/cm2 & 200°C.
- B. 15-45 Kgf/cm2 & 450-550°C.
- C. 50 - 75 kgf/cm2 & 600 - 800°C.
- D. 5-10 kgf/cm2 & 150 - 250°C.
- Correct Answer
- 15-45 Kgf/cm2 & 450-550°C.
- 1. Choose the correct statement.
Options- A. Octane number of i-octane is zero.
- B. Octane number of paraffins increases with increasing number of carbon atoms.
- C. Branched chain paraffins have higher octane number than straight chain paraffins with same number of carbon atoms.
- D. The aromatics have lower octane number than naphthenes with same number of carbon atoms. Discuss
- 2. Petroleum is believed to have originated from __________ sources.
Options- A. vegetable
- B. animal
- C. both (a) and (b)
- D. neither (a) nor (b) Discuss
- 3. Which of the following hydrocarbons of same carbon atoms has minimum smoking tendency?
Options- A. Paraffins
- B. Naphthenes
- C. Aromatics
- D. Iso-paraffins Discuss
- 4. Smoke volatility index is equal to smoke point plus
Options- A. 0.42 x(% distilled at 204°C)
- B. 5 mm
- C. 0.84 x (% distilled at 204°C)
- D. 10 mm. approximately Discuss
- 5. Which is the most effective catalyst used in catalytic cracking of petroleum products?
Options- A. Iron oxide
- B. Nickel
- C. Vanadium pentoxide
- D. Zeolite Discuss
- 6. The catalytic cracking of heavier petroleum fraction is done to produce mainly
Options- A. gasoline
- B. asphalt
- C. diesel oil
- D. tar Discuss
- 7. The characterisation factor of a crude oil is calculated as 12.5. It means that; it is
Options- A. paraffinic
- B. naphthenic
- C. intermediate
- D. none of these Discuss
- 8. In hydrofining catalytic desulphurisation process for sweetening of petroleum products, use of hydrogen
Options- A. enhances the desulphurisation process.
- B. minimises coke formation.
- C. both (a) and (b).
- D. neither (a) nor (b). Discuss
- 9. The doctor's solution comprises of sodium plumbite in
Options- A. alcohal
- B. water
- C. aqueous caustic soda
- D. soda ash Discuss
- 10. Deoiling is the process of removal of oil from wax. It is done by the __________ process.
Options- A. solvent extraction
- B. sweating
- C. resettling
- D. all (a), (b) & (c) Discuss
Petroleum Refinery Engineering problems
Search Results
Correct Answer: Branched chain paraffins have higher octane number than straight chain paraffins with same number of carbon atoms.
Correct Answer: both (a) and (b)
Correct Answer: Paraffins
Correct Answer: 0.42 x(% distilled at 204°C)
Correct Answer: Zeolite
Correct Answer: diesel oil
Correct Answer: paraffinic
Correct Answer: both (a) and (b).
Correct Answer: aqueous caustic soda
Correct Answer: all (a), (b) & (c)
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.