Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
Capacity of flight conveyor in tons/hr is given by (where, W & D = width and depth of flight respectively in metre V = speed of the conveyor, metre/second ? = bulk density of material, kg/m3)
Options- A. 3.6 W.D.V.?
- B. 3.6 W.D.V.
- C. 3.6 W.V.?
- D. 3.6 D.V.?
- Correct Answer
- 3.6 W.D.V.?
- 1. In paint industries, blending of light paste is done by using a
Options- A. masticator
- B. charge can mixer
- C. kneader
- D. none of these Discuss
- 2. In the cyclone separator used for separation of dust from dust laden gas, the gas
Options- A. enters the cyclone from the top.
- B. is admitted tangentially at high velocity.
- C. develops a helical motion inside the chamber.
- D. both (b) and (c). Discuss
- 3. The material is crushed in a gyratory crusher by the action of
Options- A. impact
- B. compression
- C. attrition
- D. cutting Discuss
- 4. Which of the following conveyors cannot be recommended for transportation of abrasive materials?
Options- A. Belt conveyor
- B. Apron conveyor
- C. Flight conveyor
- D. Chain conveyor Discuss
- 5. The porosity of a compressible cake is
Options- A. minimum at the filter medium.
- B. minimum at the upstream face.
- C. maximum at the filter medium.
- D. same throughout the thickness of cake. Discuss
- 6. Energy consumption in a crusher decreases with increase in the
Options- A. size of the product (at constant feed size).
- B. capacity of the crushing machine.
- C. size of feed (at constant reduction ratio).
- D. all (a), (b) & (c). Discuss
- 7. Size reduction of fibrous materials like wood, asbestos, mica etc. is done by a disintegrator exemplified by the
Options- A. Blake jaw crusher
- B. cage mill
- C. stamp mill
- D. Bradford's breaker Discuss
- 8. The term 'angle of nip' is concerned with the operation of the __________ crushers.
Options- A. jaw
- B. roll
- C. gyratory
- D. none of these Discuss
- 9. Vacuum filter is most suitable for the
Options- A. removal of fines from liquid.
- B. liquids having high vapour pressure.
- C. liquids of very high viscosity.
- D. none of these. Discuss
- 10. __________ mill is normally used for grinding of talc.
Options- A. Tube
- B. Compartment
- C. Ring-roll
- D. Pebble Discuss
Mechanical Operations problems
Search Results
Correct Answer: charge can mixer
Correct Answer: both (b) and (c).
Correct Answer: compression
Correct Answer: Flight conveyor
Correct Answer: minimum at the filter medium.
Correct Answer: all (a), (b) & (c).
Correct Answer: cage mill
Correct Answer: roll
Correct Answer: none of these.
Correct Answer: Ring-roll
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.