Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
To remove very small amount of tiny solid impurities from liquid, we use a
Options- A. pressure filter
- B. vacuum filter
- C. centrifugal filter
- D. coagulant
- Correct Answer
- coagulant
- 1. The maximum slope of a belt conveyor can be
Options- A. 15°
- B. 30°
- C. 45°
- D. 60° Discuss
- 2. __________ mills fall in the category of tumbling mills,
Options- A. Ball and pebble
- B. Rod and tube
- C. Compartment
- D. all (a), (b) & (c) Discuss
- 3. Separation of materials into products based on the difference of their sizes is called
Options- A. sizing
- B. sorting
- C. classification
- D. flocculation Discuss
- 4. Mass flow of granular solid (M) through a circular opening of dia, D follows
Options- A. M ? D
- B. M ? D2
- C. M ? D3
- D. M ? D Discuss
- 5. To get ultrafine particles, the equipment used is a
Options- A. ball mill
- B. rod mill
- C. hammer crusher
- D. fluid energy mill Discuss
- 6. Energy requirement (per unit mass of material crushed/ground) is highest for
Options- A. jaw crusher
- B. rod mill
- C. ball mill
- D. fluid energy mill Discuss
- 7. Colloidal mills are used for __________ grinding.
Options- A. coarse
- B. intermediate
- C. fine
- D. ultrafine Discuss
- 8. Screw conveyors are
Options- A. run at very high rpm.
- B. suitable for sticky materials.
- C. suitable for highly abrasive materials.
- D. all (a), (b) and (c) Discuss
- 9. In case of grinding in a ball mill
Options- A. wet grinding achieves a finer product size than dry grinding.
- B. its capacity decreases with increasing fineness of the products.
- C. grinding cost and power requirement increases with increasing fineness of the products.
- D. all (a), (b) and (c). Discuss
- 10. Hot, lumpy & abrasive materials are best transported by using a/an __________ conveyor.
Options- A. apron
- B. belt
- C. screw
- D. flight Discuss
Mechanical Operations problems
Search Results
Correct Answer: 30°
Correct Answer: all (a), (b) & (c)
Correct Answer: sizing
Correct Answer: M ? D3
Correct Answer: fluid energy mill
Correct Answer: fluid energy mill
Correct Answer: ultrafine
Correct Answer: suitable for sticky materials.
Correct Answer: all (a), (b) and (c).
Correct Answer: apron
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.