Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
In a mixer, the quantity, (v. L/D) is termed as __________ number(where, v = longitudinal velocity of material, L = length of the mixer, D = diffusivity in axial mixing).
Options- A. Weber
- B. Peclet
- C. Brinkman
- D. Schmidt
- Correct Answer
- Peclet
- 1. Cumulative analysis for determining surface is more precise than differential analysis, because of the
Options- A. assumption that all particles in a single fraction are equal in size.
- B. fact that screening is more effective.
- C. assumption that all particles in a single fraction are equal in size, is not needed.
- D. none of these. Discuss
- 2. A sand mixture was screened through a standard 10-mesh screen. The mass fraction of the oversize material in feed, overflow and underflow were found to be 0.38, 0.79 and 0.22 respectively. The screen effectiveness based on the oversize is
Options- A. 0.50
- B. 0.58
- C. 0.68
- D. 0.62 Discuss
- 3. The filter medium resistance is controlled by
Options- A. pressure drop alone
- B. flow rate alone
- C. both pressure drop and flow rate
- D. cake thickness Discuss
- 4. Wet seiving is employed, when the product contains __________ materials.
Options- A. abrasive
- B. large quantity of very fine
- C. coarse
- D. non-sticky Discuss
- 5. The unit of filter medium resistance is
Options- A. cm-1
- B. gm/cm-1
- C. cm/gm-1
- D. gm-1 Discuss
- 6. To get ultrafine particles, the equipment used is a
Options- A. ball mill
- B. rod mill
- C. hammer crusher
- D. fluid energy mill Discuss
- 7. Mass flow of granular solid (M) through a circular opening of dia, D follows
Options- A. M ? D
- B. M ? D2
- C. M ? D3
- D. M ? D Discuss
- 8. Separation of materials into products based on the difference of their sizes is called
Options- A. sizing
- B. sorting
- C. classification
- D. flocculation Discuss
- 9. __________ mills fall in the category of tumbling mills,
Options- A. Ball and pebble
- B. Rod and tube
- C. Compartment
- D. all (a), (b) & (c) Discuss
- 10. The maximum slope of a belt conveyor can be
Options- A. 15°
- B. 30°
- C. 45°
- D. 60° Discuss
Mechanical Operations problems
Search Results
Correct Answer: assumption that all particles in a single fraction are equal in size, is not needed.
Correct Answer: 0.50
Correct Answer: both pressure drop and flow rate
Correct Answer: large quantity of very fine
Correct Answer: cm-1
Correct Answer: fluid energy mill
Correct Answer: M ? D3
Correct Answer: sizing
Correct Answer: all (a), (b) & (c)
Correct Answer: 30°
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.