Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
The filter medium resistance is controlled by
Options- A. pressure drop alone
- B. flow rate alone
- C. both pressure drop and flow rate
- D. cake thickness
- Correct Answer
- both pressure drop and flow rate
- 1. Wet seiving is employed, when the product contains __________ materials.
Options- A. abrasive
- B. large quantity of very fine
- C. coarse
- D. non-sticky Discuss
- 2. The unit of filter medium resistance is
Options- A. cm-1
- B. gm/cm-1
- C. cm/gm-1
- D. gm-1 Discuss
- 3. The energy consumed by a ball mill depends on
Options- A. its speed.
- B. its ball load.
- C. the density of the material being ground.
- D. all (a), (b) and (c). Discuss
- 4. Ultracentrifuges running at speeds upto 100000 rpm is normally used for the
Options- A. separation of isotopes based on their density or molecular weights difference.
- B. concentration of rubber latex.
- C. separation of cream from milk.
- D. dewaxing of lubricating oil. Discuss
- 5. During size reduction by a jaw crusher, the energy consumed decreases with the
Options- A. decreasing size of product at constant size of feed.
- B. decreasing machine capacity.
- C. increasing size of feed at constant reduction ratio.
- D. none of these. Discuss
- 6. A sand mixture was screened through a standard 10-mesh screen. The mass fraction of the oversize material in feed, overflow and underflow were found to be 0.38, 0.79 and 0.22 respectively. The screen effectiveness based on the oversize is
Options- A. 0.50
- B. 0.58
- C. 0.68
- D. 0.62 Discuss
- 7. Cumulative analysis for determining surface is more precise than differential analysis, because of the
Options- A. assumption that all particles in a single fraction are equal in size.
- B. fact that screening is more effective.
- C. assumption that all particles in a single fraction are equal in size, is not needed.
- D. none of these. Discuss
- 8. In a mixer, the quantity, (v. L/D) is termed as __________ number(where, v = longitudinal velocity of material, L = length of the mixer, D = diffusivity in axial mixing).
Options- A. Weber
- B. Peclet
- C. Brinkman
- D. Schmidt Discuss
- 9. To get ultrafine particles, the equipment used is a
Options- A. ball mill
- B. rod mill
- C. hammer crusher
- D. fluid energy mill Discuss
- 10. Mass flow of granular solid (M) through a circular opening of dia, D follows
Options- A. M ? D
- B. M ? D2
- C. M ? D3
- D. M ? D Discuss
Mechanical Operations problems
Search Results
Correct Answer: large quantity of very fine
Correct Answer: cm-1
Correct Answer: all (a), (b) and (c).
Correct Answer: separation of isotopes based on their density or molecular weights difference.
Correct Answer: increasing size of feed at constant reduction ratio.
Correct Answer: 0.50
Correct Answer: assumption that all particles in a single fraction are equal in size, is not needed.
Correct Answer: Peclet
Correct Answer: fluid energy mill
Correct Answer: M ? D3
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.