Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
The opening of a 200 mesh screen (Taylor series) is
Options- A. 0.0074 cm
- B. 0.0074 mm
- C. 0.0047 cm
- D. 74 mili-microns
- Correct Answer
- 0.0074 cm
- 1. Ribbon blenders are exclusively meant for
Options- A. blending miscible liquids.
- B. non-flowing powder and thin pastes.
- C. bath mixing.
- D. continuous mixing. Discuss
- 2. Gravity stamp mill is meant for the __________ crushing.
Options- A. primary
- B. intermediate
- C. fine
- D. ultrafine Discuss
- 3. Gummy & sticky materials like molasses, sugar etc. are best transported/handled by using a __________ conveyor.
Options- A. drag
- B. ribbon
- C. screw
- D. slat Discuss
- 4. Which of the following is not a revolving/tumbling mill used for size reduction?
Options- A. Compartment mill
- B. Pebble mill
- C. Cage mill
- D. Rod mill Discuss
- 5. The most suitable filter for the removal of very small amount of precipitate from very large volumes of water is the __________ filter.
Options- A. vacuum
- B. sand
- C. plate & frame
- D. rotary Discuss
- 6. During the washing of cake
Options- A. all the resistances are constant.
- B. filter medium resistance increases.
- C. filter medium resistance decreases.
- D. cake resistance decreases. Discuss
- 7. Washability curve based on float and sink test enables an assessment to be made of the possibility of cleaning a coal fraction based on the
Options- A. density separation.
- B. differential wettability.
- C. size.
- D. volatile matter content. Discuss
- 8. A fluid energy mill is used for
Options- A. cutting
- B. grinding
- C. ultragrinding
- D. crushing Discuss
- 9. Metallic wire mesh is used as a filtering medium for the separation of dust from dust laden gas in case of a/an
Options- A. air filter
- B. bag filter
- C. venturi scrubber
- D. hydrocyclones Discuss
- 10. In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the __________ crushing.
Options- A. secondary
- B. fine
- C. primary
- D. ultrafine Discuss
Mechanical Operations problems
Search Results
Correct Answer: non-flowing powder and thin pastes.
Correct Answer: fine
Correct Answer: ribbon
Correct Answer: Cage mill
Correct Answer: sand
Correct Answer: all the resistances are constant.
Correct Answer: density separation.
Correct Answer: ultragrinding
Correct Answer: air filter
Correct Answer: primary
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.