logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Mechanical Operations Comments

  • Question
  • The important dimensional group involved in the power requirement calculation in mixing operation is the __________ number.


  • Options
  • A. Reynold's
  • B. Froude
  • C. both (a) & (b)
  • D. neither (a) nor (b)

  • Correct Answer
  • both (a) & (b) 


  • Mechanical Operations problems


    Search Results


    • 1. At low Reynold's number, the power (P) required for agitating a fluid in a stirred tank becomes independent of inertial forces. In this limit, indicate which of the following relations is satisfied:
      Po = ?/?N3 D5 : Power number
      Re = ? N D2/?: Reynold's number
      N is the impeller rotational speed, and D is the impeller diameter.

    • Options
    • A. Po ? Re-1.0
    • B. Po ? Re0.0
    • C. Po ? Re0.5
    • D. Po ? Re1.0
    • Discuss
    • 2. Critical Speed (Nc) of a ball mill is given by(where R1 and R2 are radii of ball mill and the ball respectively).

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. Use of 'grinding aids' is done in __________ grinding.

    • Options
    • A. dry
    • B. wet
    • C. ultrafine
    • D. intermediate
    • Discuss
    • 4. Which of the following is the hardest material?

    • Options
    • A. Calcite
    • B. Quartz
    • C. Corundum
    • D. Gypsum
    • Discuss
    • 5. There is practically no alternative/competitor to __________ in the beneficiation treatment of sulphide ores.

    • Options
    • A. classification
    • B. tabling
    • C. jigging
    • D. froth floatation
    • Discuss
    • 6. Sphericity of pulverised coal is

    • Options
    • A. 1
    • B. <1
    • C. >1
    • D. ?
    • Discuss
    • 7. For a sphere falling in the constant drag co-efficient regime, its terminal velocity depends on its diameter (d) as

    • Options
    • A. d
    • B. d
    • C. d2
    • D. 1/d
    • Discuss
    • 8. For a cyclone of diameter 0.2 m with a tangential velocity of 15 m/s at the wall, the separation factor is

    • Options
    • A. 2250
    • B. 1125
    • C. 460
    • D. 230
    • Discuss
    • 9. Grinding efficiency of a ball mill is of the order of __________ percent.

    • Options
    • A. 1-5
    • B. 40-50
    • C. 75-80
    • D. 90-95
    • Discuss
    • 10. Filtration capacity of a rotary drum vacuum filter depends upon the

    • Options
    • A. cake thickness.
    • B. characteristics of the feed slurry.
    • C. both (a) & (b).
    • D. neither (a) nor (b).
    • Discuss


    Comments

    There are no comments.

Enter a new Comment