Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
Temperature of the product during ultrafine grinding
Options- A. increases
- B. decreases
- C. remains constant
- D. may increase or decrease ; depends on the material being ground
- Correct Answer
- increases
- 1. Agglomeration of individual particles into clusters (flocs) is called flocculation. To prevent flocculation, the most commonly used dispersing agents are
Options- A. carbonates
- B. sulphates
- C. silicates & phosphates
- D. bi-carbonates Discuss
- 2. All resistances during washing of cake
Options- A. increases
- B. decreases
- C. remain constant
- D. none of these Discuss
- 3. The reduction ratio for fine grinders is
Options- A. 5-10
- B. 10-20
- C. 20-40
- D. as high as 100 Discuss
- 4. A straight line is obtained on plotting reciprocal of filtration rate vs. the volume of filtrate for __________ flow of filtrate.
Options- A. compressible cakes and laminar
- B. incompressible cake and laminar
- C. compressible cake and turbulent
- D. incompressible cake and turbulent Discuss
- 5. __________ conveyor is the most suitable for short distance transportation of non-abrasive loose materials like garbage, grain, food wastes etc.
Options- A. Flight
- B. Screw
- C. Drag
- D. Belt Discuss
- 6. __________ mills are termed as impactors.
Options- A. Hammer
- B. Cage
- C. Rolling-compression
- D. none of these Discuss
- 7. Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for
Options- A. British standard screens.
- B. German standard screens (DIN 1171) etc.
- C. American standard screens (ASTM and Tyler standard screens).
- D. all (a), (b) and (c). Discuss
- 8. Size measurement of ultrafine particles can be best expressed in terms of
Options- A. centimetre
- B. screen size
- C. micron
- D. surface area per unit mass Discuss
- 9. Which is a secondary crusher for a hard & tough stone?
Options- A. Jaw crusher
- B. Cone crusher
- C. Impact crusher
- D. Toothed roll crusher Discuss
- 10. Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
Options- A. 0.5 D
- B. D
- C. 1.5 D
- D. 2 D Discuss
Mechanical Operations problems
Search Results
Correct Answer: silicates & phosphates
Correct Answer: remain constant
Correct Answer: as high as 100
Correct Answer: incompressible cake and laminar
Correct Answer: Flight
Correct Answer: Hammer
Correct Answer: all (a), (b) and (c).
Correct Answer: surface area per unit mass
Correct Answer: Cone crusher
Correct Answer: D
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.