Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
In case of a hammer crusher, the
Options- A. feed may be highly abrasive (Moh's scale >5).
- B. minimum product size is 3 mm.
- C. maximum feed size may be 50 mm.
- D. rotor shaft carrying hammers can be vertical or horizontal.
- Correct Answer
- rotor shaft carrying hammers can be vertical or horizontal.
- 1. __________ is defined as the geometric mean of the relative rejections and the relative recoveries of two minerals.
Options- A. Separation efficiency
- B. Selectivity index
- C. Concentration ratio
- D. none of these Discuss
- 2. Which of the following is used for primary crushing of very hard lumpy materials?
Options- A. Toothed roll crusher
- B. Gyratory crusher
- C. Ball mill
- D. Tube mill Discuss
- 3. Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a
Options- A. disc bowl centrifuge.
- B. sharpies supercentrifuge.
- C. batch basket centrifuge.
- D. sparkler filter. Discuss
- 4. increasing the capacity of a screen __________ the screen effectiveness.
Options- A. decreases.
- B. increases
- C. does not effect
- D. none of these Discuss
- 5. Trommels separate a mixture of particles depending on their
Options- A. size
- B. density
- C. wettability
- D. electrical & magnetic properties Discuss
- 6. Sphericity of a cubical particle, when its equivalent diameter is taken as the height of the cube, is
Options- A. 0.5
- B. 1
- C. 2
- D. 3 Discuss
- 7. Filtration of water in a paper mill is done by a/an __________ filter.
Options- A. open sand
- B. plate and frame
- C. vacuum leaf
- D. sparkler Discuss
- 8. A tube mill compared to a ball mill
Options- A. has a higher length/diameter ratio.
- B. produces a coarser product.
- C. has a higher diameter/length ratio.
- D. uses much larger balls. Discuss
- 9. Screen capacity is not a function of
Options- A. its openings size.
- B. screening mechanism.
- C. screening surface.
- D. atmospheric humidity. Discuss
- 10. Which is the most suitable conveyor for transportation of sticky material?
Options- A. Apron conveyor
- B. Belt conveyor
- C. Screw conveyor
- D. Pneumatic conveyor Discuss
Mechanical Operations problems
Search Results
Correct Answer: Selectivity index
Correct Answer: Gyratory crusher
Correct Answer: disc bowl centrifuge.
Correct Answer: decreases.
Correct Answer: size
Correct Answer: 1
Correct Answer: open sand
Correct Answer: has a higher length/diameter ratio.
Correct Answer: atmospheric humidity.
Correct Answer: Screw conveyor
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.