logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Polymer Technology Comments

  • Question
  • __________ polythene is most prone to stress-cracking


  • Options
  • A. High density
  • B. Low density
  • C. Cross-linked
  • D. Linear low density

  • Correct Answer
  • High density 


  • Polymer Technology problems


    Search Results


    • 1. Terylene is a/an

    • Options
    • A. addition polymer
    • B. poly amide
    • C. homopolymer
    • D. none of these
    • Discuss
    • 2. Polymers are

    • Options
    • A. micromolecules
    • B. macromolecules
    • C. sub-micromolecules
    • D. none of these
    • Discuss
    • 3. Adipic acid is an intermediate in the manufacture of

    • Options
    • A. perspex
    • B. nylon-66
    • C. polystyrene
    • D. bakelite
    • Discuss
    • 4. Styrene which is a monomer for the production of polystyrene, is commercially produced by the

    • Options
    • A. catalytic dehydrogenation of ethyl benzene.
    • B. dehydration of ethyl alcohol followed by hydrogenation.
    • C. reacting ethylene oxide with acetal-dehyde.
    • D. fermentation of starch.
    • Discuss
    • 5. Bakelite (phenol-formaldehyde) resin can not be used as

    • Options
    • A. decorative paint.
    • B. decorative laminates.
    • C. electrical insulation.
    • D. glass reinforced plastics.
    • Discuss
    • 6. Thermocole (expanded polystyrene) is not used for

    • Options
    • A. low temperature thermal insulation as in refrigerator and air conditioners.
    • B. accoustic control and ceiling for building.
    • C. high temperature thermal insulation in furnaces.
    • D. packing of delicate electronic gadgets.
    • Discuss
    • 7. The repeating units of PTFE are

    • Options
    • A. Cl2CH-CH3
    • B. F2 C = CF2
    • C. F3 C-CF3
    • D. FClC = CF2
    • Discuss
    • 8. Orion is

    • Options
    • A. a copolymer.
    • B. a condensation polymer.
    • C. obtained by polymerising vinyl cyanide.
    • D. all (a), (b) and (c).
    • Discuss
    • 9. Acrylonitrile-butadiene-styrene (ABS) copolymer, which is produced by blending styrene-acrylonitfile copolymer with butadiene based elastomer, is a/an

    • Options
    • A. rigid foam
    • B. engineering plastic
    • C. thermosetting polymer
    • D. spongy rubber
    • Discuss
    • 10. The rate controlling step in the manufacture of silicone rubber is the

    • Options
    • A. polymer termination step.
    • B. condensation of siloxane to silicone.
    • C. initial hydrolysis of silicone monomer.
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment