logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Polymer Technology Comments

  • Question
  • Unbreakable crockeries are made from __________ polymers.


  • Options
  • A. polystyrene
  • B. melamine
  • C. polystyrene
  • D. polyurathane

  • Correct Answer
  • melamine 


  • Polymer Technology problems


    Search Results


    • 1. Bakelite is

    • Options
    • A. same as polytetra flouro ethylene (PTFE).
    • B. an inorganic polymer.
    • C. same as thermoset phenol formaldehyde.
    • D. not a polymer.
    • Discuss
    • 2. Synthetic rubber

    • Options
    • A. deforms, if stretched to double of its original dimension.
    • B. is brittle at low temperature
    • C. is softer at higher temperature.
    • D. is highly permeable to air & water and is readily attacked by chemicals & atmospheric gases.
    • Discuss
    • 3. Vulcanisation of rubber does not increase its

    • Options
    • A. elasticity
    • B. plasticity
    • C. ductility
    • D. none of these
    • Discuss
    • 4. Properties of a polymer is affected by the

    • Options
    • A. chain length.
    • B. intermolecular forces.
    • C. branching & cross-linking.
    • D. all (a), (b).
    • Discuss
    • 5. Thermosplastic materials

    • Options
    • A. do not soften on application of heat.
    • B. are heavily branched molecules.
    • C. are solvent insoluble.
    • D. none of these.
    • Discuss
    • 6. Condensation polymerisation of caprolac-tum is carried out in the reactor maintained at a temperature of __________ °C for producing nylon-6.

    • Options
    • A. -20 to 25
    • B. 50 to 75
    • C. 100 to 150
    • D. 250-280
    • Discuss
    • 7. In a co-polymer, the repeating units contain two different monomers. Which of the following is a copolymer?

    • Options
    • A. PTFE
    • B. Buna-S
    • C. PMMA
    • D. Polycaprolactum
    • Discuss
    • 8. Silicone resins, which are highly water repellant and has good heat resistance can not be used

    • Options
    • A. as room temperature adhesive.
    • B. as grease & lubricant.
    • C. hydraulic fluid for heat transfer.
    • D. resin for lamination.
    • Discuss
    • 9. Nylon-66 compared to nylon-6 has

    • Options
    • A. lower melting point.
    • B. more abrasion resistant properties.
    • C. higher hardness.
    • D. all (a), (b) and (c).
    • Discuss
    • 10. Which of the following is not the commercial name of polymethylmethacrylate (PMMA)?

    • Options
    • A. Perspex
    • B. Lucite
    • C. Plexiglass
    • D. Teflon
    • Discuss


    Comments

    There are no comments.

Enter a new Comment