Discussion
Home ‣ Chemical Engineering ‣ Polymer Technology Comments
- Question
Nylon 6 as compared to nylon 6, 6 has lower
Options- A. abrasion resistance.
- B. thermal stability.
- C. adhesion to rubber.
- D. hardness.
- Correct Answer
- abrasion resistance.
- 1. Temperature and gage pressure maintained during the manufacture of cold SBR (styrene butadiene rubber) are
Options- A. 5°C and 1 kgf/cm2.
- B. - 20°C and 1 kgf/cm2.
- C. 0°C and 1 kgf/cm2.
- D. 0°C and 3 kgf/cm2. Discuss
- 2. __________ is an addition polymer
Options- A. Nylon
- B. Bakelite
- C. Polythene
- D. none of these Discuss
- 3. Viscosity of a polymer solution or melt
Options- A. decreases with increase in molecular weight.
- B. decreases with increase in temperature.
- C. increases with increase in temperature.
- D. does not vary with temperature rise. Discuss
- 4. Pick out the correct statement.
Options- A. Plastics are good conductors of heat and electricity.
- B. All the polymers are highly crystalline in nature
- C. Polymers can be vaporised by heating to a very high temperature.
- D. The liquid polymer becomes greasy, then waxy and finally solid on increasing the degree of polymerisation. Discuss
- 5. Which of the following is stretched into fibres?
Options- A. Saturated polyester
- B. Unsaturated polyester
- C. Isoprene
- D. Bakelite Discuss
- 6. Which of the following is not a polymer of two monomers?
Options- A. Teflon
- B. Bakelite
- C. SBR
- D. None of these Discuss
- 7. Which of the following is not a polyolefin?
Options- A. Polystyrene
- B. Polypropylene
- C. Neoprene
- D. None of these Discuss
- 8. __________ is a homopolymer.
Options- A. Neoprene
- B. Bakelite
- C. Nylon-66
- D. Terylene Discuss
- 9. Which of the following is the most important rubber compounding ingradient which is used to improve wearing qualities of both natural rubber & SBR by imparting toughness?
Options- A. Phosphorous
- B. Carbon black
- C. Pine oil
- D. Rosin Discuss
- 10. Plastic tubes & pipes are generally made by __________ moulding.
Options- A. injection
- B. transfer
- C. extrusion
- D. compression Discuss
Polymer Technology problems
Search Results
Correct Answer: 5°C and 1 kgf/cm2.
Correct Answer: Polythene
Correct Answer: increases with increase in temperature.
Correct Answer: The liquid polymer becomes greasy, then waxy and finally solid on increasing the degree of polymerisation.
Correct Answer: Saturated polyester
Correct Answer: Teflon
Correct Answer: Neoprene
Correct Answer: Neoprene
Correct Answer: Carbon black
Correct Answer: extrusion
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.