Discussion
Home ‣ Chemical Engineering ‣ Polymer Technology Comments
- Question
__________ is an addition polymer
Options- A. Nylon
- B. Bakelite
- C. Polythene
- D. none of these
- Correct Answer
- Polythene
- 1. Viscosity of a polymer solution or melt
Options- A. decreases with increase in molecular weight.
- B. decreases with increase in temperature.
- C. increases with increase in temperature.
- D. does not vary with temperature rise. Discuss
- 2. Pick out the correct statement.
Options- A. Plastics are good conductors of heat and electricity.
- B. All the polymers are highly crystalline in nature
- C. Polymers can be vaporised by heating to a very high temperature.
- D. The liquid polymer becomes greasy, then waxy and finally solid on increasing the degree of polymerisation. Discuss
- 3. Which of the following is stretched into fibres?
Options- A. Saturated polyester
- B. Unsaturated polyester
- C. Isoprene
- D. Bakelite Discuss
- 4. Low density polythene as compared to high density polythene is
Options- A. harder
- B. tougher
- C. chemically inert
- D. more flexible Discuss
- 5. Perspex can be used as a substitute of glass. Its monomer is
Options- A. methyl methacrylate
- B. DMT
- C. butadiene
- D. tetrafluroethylene Discuss
- 6. Temperature and gage pressure maintained during the manufacture of cold SBR (styrene butadiene rubber) are
Options- A. 5°C and 1 kgf/cm2.
- B. - 20°C and 1 kgf/cm2.
- C. 0°C and 1 kgf/cm2.
- D. 0°C and 3 kgf/cm2. Discuss
- 7. Nylon 6 as compared to nylon 6, 6 has lower
Options- A. abrasion resistance.
- B. thermal stability.
- C. adhesion to rubber.
- D. hardness. Discuss
- 8. Which of the following is not a polymer of two monomers?
Options- A. Teflon
- B. Bakelite
- C. SBR
- D. None of these Discuss
- 9. Which of the following is not a polyolefin?
Options- A. Polystyrene
- B. Polypropylene
- C. Neoprene
- D. None of these Discuss
- 10. __________ is a homopolymer.
Options- A. Neoprene
- B. Bakelite
- C. Nylon-66
- D. Terylene Discuss
Polymer Technology problems
Search Results
Correct Answer: increases with increase in temperature.
Correct Answer: The liquid polymer becomes greasy, then waxy and finally solid on increasing the degree of polymerisation.
Correct Answer: Saturated polyester
Correct Answer: more flexible
Correct Answer: methyl methacrylate
Correct Answer: 5°C and 1 kgf/cm2.
Correct Answer: abrasion resistance.
Correct Answer: Teflon
Correct Answer: Neoprene
Correct Answer: Neoprene
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.