logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Polymer Technology Comments

  • Question
  • Low density polythene as compared to high density polythene is


  • Options
  • A. harder
  • B. tougher
  • C. chemically inert
  • D. more flexible

  • Correct Answer
  • more flexible 


  • Polymer Technology problems


    Search Results


    • 1. Perspex can be used as a substitute of glass. Its monomer is

    • Options
    • A. methyl methacrylate
    • B. DMT
    • C. butadiene
    • D. tetrafluroethylene
    • Discuss
    • 2. Polymethyl methacrylate, which is an acrylic resin, is also called

    • Options
    • A. thiokol
    • B. plexiglass or lucite
    • C. dacron
    • D. teflon
    • Discuss
    • 3. __________ polymer is produced by the copolymerisation of vinyl chloride-vinyl acetate.

    • Options
    • A. Fibrous
    • B. Leathery
    • C. Rubbery
    • D. Hard
    • Discuss
    • 4. Ion exchange resins are made of

    • Options
    • A. lucite
    • B. sulphonated bakelite
    • C. polystyrene
    • D. teflon
    • Discuss
    • 5. Chromite refractories are used in

    • Options
    • A. bottom of soaking pits.
    • B. between acid & basic linings in basic open hearth furnaces to prevent their chemical action with each other.
    • C. both (a) & (b)
    • D. neither (a) and (b)
    • Discuss
    • 6. Which of the following is stretched into fibres?

    • Options
    • A. Saturated polyester
    • B. Unsaturated polyester
    • C. Isoprene
    • D. Bakelite
    • Discuss
    • 7. Pick out the correct statement.

    • Options
    • A. Plastics are good conductors of heat and electricity.
    • B. All the polymers are highly crystalline in nature
    • C. Polymers can be vaporised by heating to a very high temperature.
    • D. The liquid polymer becomes greasy, then waxy and finally solid on increasing the degree of polymerisation.
    • Discuss
    • 8. Viscosity of a polymer solution or melt

    • Options
    • A. decreases with increase in molecular weight.
    • B. decreases with increase in temperature.
    • C. increases with increase in temperature.
    • D. does not vary with temperature rise.
    • Discuss
    • 9. __________ is an addition polymer

    • Options
    • A. Nylon
    • B. Bakelite
    • C. Polythene
    • D. none of these
    • Discuss
    • 10. Temperature and gage pressure maintained during the manufacture of cold SBR (styrene butadiene rubber) are

    • Options
    • A. 5°C and 1 kgf/cm2.
    • B. - 20°C and 1 kgf/cm2.
    • C. 0°C and 1 kgf/cm2.
    • D. 0°C and 3 kgf/cm2.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment