Discussion
Home ‣ Chemical Engineering ‣ Refractory Technology Comments
- Question
Slide gates in teeming laddie used for steel pouring in ingot moulds is lined with __________ bricks.
Options- A. bakelite impregnated or fused periclase
- B. silica
- C. semi-silica
- D. fireclay
- Correct Answer
- bakelite impregnated or fused periclase
- 1. Thermal conductivity of refractory bricks
Options- A. increases with decrease in porosity.
- B. decreases with decreases in porosity.
- C. is independent of its porosity and is maximum for insulating bricks.
- D. increases with the amount of air entrapped in pores. Discuss
- 2. Addition of grog in fireclay brick during its manufacture is advantageous, because it results in
Options- A. less shrinkage in heating, decreased apparent porosity & increased specific gravity.
- B. high strength & thermal spalling resistance.
- C. less addition of water to get a workable plasticity & lesser time required for drying the raw refractories and hence increased rate of production.
- D. all (a), (b) and (c). Discuss
- 3. Fireclay bricks are not used in the
Options- A. blast furnace
- B. hot blast stove
- C. cupola
- D. wall of coke oven Discuss
- 4. Lower wall courses of soaking pits are made of __________ bricks to avoid the action of molten slag & scale.
Options- A. chrome or magnesite
- B. silicon carbide
- C. silica
- D. lowduty fireclay Discuss
- 5. Which is not a natural insulating material?
Options- A. Diatomaceous earth/kieselgur
- B. Asbestos
- C. Vermiculite
- D. None of these Discuss
- 6. Which is not an acidic refractory?
Options- A. Silica
- B. Fireclay
- C. High alumina refractory
- D. Carbon black Discuss
- 7. Which is an acidic refractory?
Options- A. Magnesite
- B. Dolomite
- C. Fireclay
- D. Chrome magnesite Discuss
- 8. Which form of silica has the highest specific gravity?
Options- A. Quartz
- B. Cristobalite
- C. Tridymite
- D. All have the same specific gravity Discuss
- 9. Pure bauxite is the best raw material for the manufacture of high alumina refractories, in which maximum alumina content can be as high as __________ percent.
Options- A. 55
- B. 70
- C. 80
- D. 90 Discuss
- 10. Permeability of bricks is a measure of the
Options- A. refractoriness.
- B. melting point.
- C. rate at which a fluid will pass through the pores.
- D. expansion during heating. Discuss
Refractory Technology problems
Search Results
Correct Answer: increases with decrease in porosity.
Correct Answer: all (a), (b) and (c).
Correct Answer: wall of coke oven
Correct Answer: chrome or magnesite
Correct Answer: None of these
Correct Answer: Carbon black
Correct Answer: Fireclay
Correct Answer: Quartz
Correct Answer: 90
Correct Answer: rate at which a fluid will pass through the pores.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.