Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
Steam economy is defined as the amount of evaporation per unit amount of steam used, while the capacity is the total evaporation obtained per hour. Use of multiple effect in evaporation
Options- A. increases capacity.
- B. increases economy.
- C. does not affect the capacity.
- D. both 'b' & 'c'.
- Correct Answer
- both 'b' & 'c'.
- 1. A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is
Options- A. bending
- B. deformation
- C. shear
- D. elongation Discuss
- 2. Tube height in a calendria type evaporator is normally less than __________ metres.
Options- A. 1
- B. 2
- C. 3.5
- D. 5.5 Discuss
- 3. Pick out the wrong statement pertaining to shell and tube heat exchanger.
Options- A. Clearance between shell & baffles and between tube & baffles should be minimum to avoid by-passing of the fluid, but it should be enough to permit the removal of tube bundle.
- B. Baffles are supported independently of the tubes by tie rods and positioned by spacers.
- C. Tie rods are fixed at one end in the tube sheet by making blind holes and the minimum number of tie rods is 4 with at least 10 mm diameter.
- D. Bracket supports are used for horizontal shell, while saddle support is used for vertical shell. Discuss
- 4. Optimum economic pipe diameter for fluid flow is determined by the
Options- A. viscosity of the fluid.
- B. density of the fluid.
- C. total cost considerations (pumping cost plus fixed cost of the pipe).
- D. none of these. Discuss
- 5. __________ heat exchanger is also known as 'hair pin type' exchanger,
Options- A. Double pipe
- B. Finned
- C. Plate type
- D. Regenerative Discuss
- 6. Souders Brown equation given by,
, is used for the calculation of the __________ in a continuous distillation column.
Options- A. diameter of the bubble cap column
- B. diameter of the seive plate column
- C. tray pressure drop
- D. residence time in the downcomer for the disengagement of entrained vapour Discuss
- 7. What is the slope of the feed line, if the feed to a distillation column is a saturated liquid?
Options- A. 0
- B. ?
- C. > 1
- D. < 1 Discuss
- 8. The ratio of volumes of the mixed reactor to the plug flow reactor (for identical feed composition, flow rate, conversion, and for all positive reaction orders) is always
Options- A. 1
- B. < 1
- C. >1
- D. equal to the order of reaction Discuss
- 9. In a double pipe (concentric) heat exchanger, the hydraulic radius for heat transfer (for a fluid flowing through the annulus) would be
Options- A. same as that for fluid flow.
- B. less than that for fluid flow.
- C. more than that for fluid flow.
- D. D2 - D1 (D1 and D2 are I.D. of inner and outer pipes respectively). Discuss
- 10. Pressure differential maintained across a continuous rotary vacuum filter is in the range of __________ mm Hg column.
Options- A. 50 to 100
- B. 100 to 150
- C. 250 to 500
- D. 600 to 700 Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: bending
Correct Answer: 2
Correct Answer: Bracket supports are used for horizontal shell, while saddle support is used for vertical shell.
Correct Answer: total cost considerations (pumping cost plus fixed cost of the pipe).
Correct Answer: Double pipe
Correct Answer: diameter of the bubble cap column
Correct Answer: ?
Correct Answer: >1
Correct Answer: more than that for fluid flow.
Correct Answer: 250 to 500
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.