Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
for a Tee (used as elbow, entering run) would be around
5
60
200
350
Correct Answer:
60
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
A minimum clearance of about __________ mm is maintained between the distillation column wall and the bubble cap.
The distance between the centre of a rivet hole to the nearest edge of the plate is called
Vertical storage vessels are never supported by __________ support.
Power required for agitation depends upon the
Wind load consideration in the design of a support can be neglected, when the vessel is
Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
The ratio of lateral strain to linear strain is termed as the
Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments