Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
The distance between the top of the slots and the liquid surface when the static liquid is just ready to flow over the overflow weir is called
Options- A. downcomer liquid seal
- B. static submergence
- C. skirt clearance
- D. none of these
- Correct Answer
- static submergence
- 1. __________ head is the most economical for cylindrical vessels designed for operating at high pressure (> 15 atm.).
Options- A. Hemispherical
- B. Dished
- C. Ellipsoidal
- D. Conical Discuss
- 2. Bubble cap diameter used for the distillation column having diameter ranging from 1.5 to 4.5 metres is about __________ mm.
Options- A. 10
- B. 50
- C. 100
- D. 150 Discuss
- 3. The ratio of linear stress to linear strain is termed as the
Options- A. modulus of elasticity
- B. modulus of rigidity
- C. bulk modulus
- D. none of these Discuss
- 4. Diameter of rivet hole (d, mm) and the plate thickness (t, mm) are related by Unwin's formula as
Options- A. d = 1.1 t
- B. d = 1.6 t
- C. d = 1.5 t
- D. 3t Discuss
- 5. Which of the following packing materials provides for maximum mass transfer?
Options- A. Lessig rings.
- B. Raschig rings.
- C. Cross-partition rings.
- D. All give the same value. Discuss
- 6. The approximate liquid depth in an agitation tank is equal to (where, d = tank diameter)
Options- A. 0.5 d
- B. 0.75 d
- C. d
- D. 2 d Discuss
- 7. For given number of passes, pitch & tube diameter, the maximum number of tubes that can be accommodated in a shell of tripled inside diameter will be __________ times.
Options- A. about 9
- B. considerably more than 9
- C. considerably less than 9
- D. about 3 Discuss
- 8. A binary liquid azeotropic mixture has boiling point lower than either of the components, when it shows __________ deviation from Raoult's Law.
Options- A. positive
- B. negative
- C. no
- D. none of these Discuss
- 9. Baffle width is normally taken as __________ times the tank diameter.
Options- A. 0.1-0.12
- B. 0.4-0.5
- C. 0.45-0.6
- D. 0.2-0.45 Discuss
- 10. The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)
Options- A. 4 A/P
- B. A/P
- C. 4 P/A
- D. A Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: Ellipsoidal
Correct Answer: 100
Correct Answer: modulus of elasticity
Correct Answer: d = 1.6 t
Correct Answer: Cross-partition rings.
Correct Answer: d
Correct Answer: considerably more than 9
Correct Answer: positive
Correct Answer: 0.1-0.12
Correct Answer: 4 A/P
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.