In which of the following evaporators, steam is fed inside the tube while the li

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments

Question
In which of the following evaporators, steam is fed inside the tube while the liquor is outside the tube?
Options
A. Long tube vertical evaporator
B. Short tube vertical evaporator
C. Horizontal tube evaporator
D. None of these

Correct Answer

Horizontal tube evaporator

Process Equipment and Plant Design problems

Search Results

1. Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger?
Options
A. 75% cut segmental baffle.
B. 25% cut segmental baffle.
C. Orifice baffle.
D. Disk and doughnut baffle.

2. In seive plate column, holes are drilled or punched in sizes ranging from 2.5 to 12 mm (5 mm being widely used). The hole pitch is normally __________ times the hole diameter to give the required hole area.
Options
A. 0.5 to 1.5
B. 2.5 to 4.0
C. 5 to 10
D. 10 to 15

3. Pick out the wrong statement pertaining to the design of a long tube vertical evaporator.
Options
A. Tube dia is 3-6 cms, while tube length in 3-6 metres.
B. Steam is fed to the shell, whereas the liquor is filled inside the tube.
C. Liquor level is maintained at l/3rd to 1/2 of the height of the tube.
D. none of these.

4. Pick out the wrong statement.
Options
A. Plate efficiency increases with increase in superficial vapour velocity till entrainment limit.
B. Increase in depth of the liquid about the slots increases the plate efficiency, particularly if the liquid depth is < 1".
C. Too small a plate spacing can cause a low efficiency, if the vapour velocity is greater than the allowable value.
D. none of these.

7. Liquid gradient over the tray results due to the
Options
A. resistance offered to flow of liquids by caps & risers and the flow of gas.
B. low gas velocity.
C. large plate spacing.
D. large reflux ratio.

9. Pick out the wrong statement.
Options
A. An air cooled finned pipe is diagram-matically represented by
B. A heat exchanger is diagrammatically represented by
C. A 90� welded elbow is diagrammatically represented by
D. A pipe still heater is diagrammatically represented by

Comments

More in Chemical Engineering: