Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
In the agitators, the power required will be changed with the increase of diameter of agitator (D) as
Options- A. D2
- B. D5
- C. D
- D. D9
- Correct Answer
- D5
- 1. Circumferential (hoop) stress in a thin cylindrical vessel under internal pressure is __________ the longitudinal stress.
Options- A. half
- B. equal to
- C. twice
- D. eight times Discuss
- 2. The normal range of velocity of steam in pipes is __________ m/sec.
Options- A. 0.1-0.5
- B. 1-5
- C. 10-20
- D. 80-100 Discuss
- 3. The difficulty of liquid distribution in packed towers is accentuated, when the ratio of tower diameter to packing diameter is
Options- A. < 30
- B. < 7
- C. > 7 < 15
- D. > 20 < 50 Discuss
- 4. Hazards associated with the relief valve leakage for extremely hazardous material storage can be taken care of by providing
Options- A. rupture diaphragm
- B. dikes
- C. surge chamber
- D. none of these Discuss
- 5. The retention time of material in a rotary dryer depends upon its
Options- A. rpm
- B. slope & length
- C. flights arrangement
- D. all (a), (b) and (c) Discuss
- 6. With increase in temperature drop (in a shell and tube heat exchanger), the LMTD correction factor, FT
Options- A. decreases very rapidly
- B. increases very rapidly
- C. remains constant
- D. increases linearly Discuss
- 7. An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by
Options- A. an increase in liquid viscosity.
- B. an increase in relatived volatility for rectification columns.
- C. decrease in gas solubility for absorbers.
- D. all (a), (b) and (c). Discuss
- 8. What is the slope of the operating line in the stripping section of a distillation column?
Options- A. 0
- B. ?
- C. > 1
- D. < 1 Discuss
- 9. The ratio of down take area to cross-sectional area of the tube, for calendria type evaporator ranges from
Options- A. 0.5 to 1
- B. 1 to 1.5
- C. 1.5 to 2
- D. 2 to 2.5 Discuss
- 10. A forced circulation long tube vertical evaporator as compared to the natural circulation evaporator
Options- A. is economical in operation.
- B. employs high velocity, high heat transfer rate and less heating surface requirement.
- C. employs a centrifugal pump placed between external downtake from vapor drum and inlet to tube bundle.
- D. both (b) & (c). Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: twice
Correct Answer: 80-100
Correct Answer: < 7
Correct Answer: rupture diaphragm
Correct Answer: all (a), (b) and (c)
Correct Answer: decreases very rapidly
Correct Answer: all (a), (b) and (c).
Correct Answer: > 1
Correct Answer: 0.5 to 1
Correct Answer: both (b) & (c).
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.