logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Stoichiometry Comments

  • Question
  • The elevation in boiling point of a solution is proportional to the __________ of the solution.


  • Options
  • A. molal concentration
  • B. reciprocal of the molal concentration
  • C. normality
  • D. molarity

  • Correct Answer
  • molal concentration 


  • Stoichiometry problems


    Search Results


    • 1. Pick out the wrong statement.

    • Options
    • A. The evaporation of aqueous solution of glucose causes its molarity to increase.
    • B. Both the freezing point as well as boiling point of sea water is more than that of distilled water.
    • C. The solution containing equal masses of two liquids 'X' and 'Y' has the same mole fraction of' 'X' and 'Y'.
    • D. both (b) and (c)
    • Discuss
    • 2. 1 torr is equivalent to

    • Options
    • A. 1 mm Hg
    • B. 1 Pascal
    • C. 1 ata
    • D. 1 mm wc
    • Discuss
    • 3. Number of gram equivalent of solute dissolved in one litre of solution is called its

    • Options
    • A. normally
    • B. molarity
    • C. molality
    • D. formality
    • Discuss
    • 4. Which of the following expressions defines the Baume gravity scale for liquids heavier than water?

    • Options
    • A. (141.5/G) - 131.5
    • B. 145 - (145/G)
    • C. 200(G-1)
    • D. (400/G) - 400
    • Discuss
    • 5. Steam reforming of naphtha produces ammonia synthesis gas. This is a/an __________ process.

    • Options
    • A. autocatalytic
    • B. endothermic
    • C. exothermic
    • D. non-catalytic
    • Discuss
    • 6. In a binary liquid solution of components A and B, if component A exhibits positive deviation from Raoult's law, then component B

    • Options
    • A. exhibits positive deviation from Raoult's law.
    • B. exhibits negative deviation from Raoult's law.
    • C. obeys Raoult's law.
    • D. may exhibit either positive or negative deviation from Raoult's law.
    • Discuss
    • 7. Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m3 . The diffusivity of aniline in air is 0.74xl0-5m2/s.The numerical value of mass transfer co-efficient is 7.4 x 10-3. The rate of evaporation of aniline is 2.97 x 10-4. Its units are

    • Options
    • A. mole/s
    • B. mole/cm2. s
    • C. mole/m2 . s
    • D. kmole/m2 . s
    • Discuss
    • 8. Volume percent for gases is equal to the

    • Options
    • A. weight percent.
    • B. mole percent.
    • C. weight percent only for ideal gases.
    • D. mole percent only for ideal gases.
    • Discuss
    • 9. Mass number of an atom is the sum of the numbers of

    • Options
    • A. neutrons and protons
    • B. protons and electrons
    • C. neutrons and electrons
    • D. both(a)&(b)
    • Discuss
    • 10. Heat of reaction is not influenced by

    • Options
    • A. the route/method through which final products are obtained.
    • B. the physical state (e.g., solid, liquid or gaseous) of reactants and products.
    • C. whether the reaction is carried out at constant temperature or constant pressure.
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment