Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
Odometer is an instrument used for measurement of
Options- A. power
- B. fuel consumption
- C. engine r.p.m.
- D. distance
- Correct Answer
- distance
- 1. Wheel base of a vehicle is the
Options- A. distance between the centres of the front and rear wheels
- B. distance between the centres of the front tyres
- C. distance between the centres of the rear tyres
- D. extreme length of the vehicle Discuss
- 2. The component of the oil filter that prevents the passage of metal particles and sludge is
Options- A. element
- B. relief valve
- C. check valve
- D. case Discuss
- 3. The Diesel engines as compared to petrol engines require
Options- A. bigger flywheel
- B. smaller flywheel
- C. same size of flywheel
- D. no flywheel Discuss
- 4. Bead wires are made of
Options- A. steel
- B. copper
- C. zinc
- D. aluminium Discuss
- 5. The brake warning light warns the driver of
Options- A. water in the master cylinder
- B. air in the hydraulic system
- C. failure of the primary or secondary circuit of hydraulic system
- D. power-brake failure Discuss
- 6. Two speed reverse gear arrangement is generally provided in case of
Options- A. passenger cars
- B. metadors
- C. tractors
- D. trucks Discuss
- 7. The advantage of a tubeless tyre over tube type tyre is
Options- A. slow air leakage
- B. better fuel efficiency
- C. less chances of running flat
- D. all of these Discuss
- 8. The seat belt tensioners are built in the
Options- A. front seats
- B. shoulder anchors
- C. seat belt retractors
- D. seat belt buckles Discuss
- 9. In a forced feed lubrication system, the device used to guard against excessive oil pressure, is known as
Options- A. release chamber
- B. balancer
- C. relief valve
- D. stop valve Discuss
- 10. The power source for a brake booster is
Options- A. exhaust manifold pressure
- B. electricity
- C. the pressure difference between the atmospheric pressure and the vaccum pressure in the intake manifold
- D. hydraulic pump Discuss
Automobile Engineering problems
Search Results
Correct Answer: distance between the centres of the front and rear wheels
Correct Answer: element
Correct Answer: bigger flywheel
Correct Answer: steel
Correct Answer: failure of the primary or secondary circuit of hydraulic system
Correct Answer: tractors
Correct Answer: all of these
Correct Answer: seat belt retractors
Correct Answer: relief valve
Correct Answer: the pressure difference between the atmospheric pressure and the vaccum pressure in the intake manifold
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.