Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
In a four wheel drive (4WD), the number of gear boxes are
Options- A. 1
- B. 2
- C. 3
- D. 4
- Correct Answer
- 2
- 1. The engine oil level should be checked
Options- A. immediately after the ignition switch is turned off
- B. while the engine is running
- C. a few minutes after the ignition switch is turned off
- D. while the engine is running at high-idle speed Discuss
- 2. The crankshaft of a typical in-line four cylinder engine has __________ balance weights.
Options- A. 12
- B. 4
- C. 16
- D. 8 Discuss
- 3. The specific gravity of acid in a fully charged battery is generally
Options- A. 1.00
- B. 1.28
- C. 1.82
- D. 2.81 Discuss
- 4. Highest useful compression ratio (HUCR) is the highest compression ratio at which the
Options- A. engine can run
- B. engine gives maximum output
- C. engine is most efficient
- D. fuel can be used in a test engine without knocking Discuss
- 5. The function of a governor in automobiles is to
Options- A. limit the power
- B. limit the vehicle speed
- C. maintain constant engine speed
- D. maximise the fuel economy Discuss
- 6. If the valve clearances are excessively large, the problem that can arise is
Options- A. overheating of the engine
- B. incomplete valve closure
- C. fouling of spark plug by gasoline
- D. none of these Discuss
- 7. Which of the following oil is more viscous?
Options- A. SAE 30
- B. SAE 40
- C. SAE 70
- D. SAE 80 Discuss
- 8. A heat treated glass generally used in automobiles bursts into __________ upon cracking,
Options- A. sharp edged fragments
- B. small particles Discuss
- 9. A maintenance free battery
Options- A. has lead-antimony plate grid
- B. has lead-calcium plate grid
- C. does not contain acid
- D. does not contain water Discuss
- 10. When the vehicle is at rest, the clutch is in engaged position.
Options- A. Correct
- B. Incorrect Discuss
Automobile Engineering problems
Search Results
Correct Answer: a few minutes after the ignition switch is turned off
Correct Answer: 8
Correct Answer: 1.28
Correct Answer: fuel can be used in a test engine without knocking
Correct Answer: maintain constant engine speed
Explanation:
The function of a governor in automobiles is to limit fuel to the engine to a maximum safe speed when unloaded and to maintain a relatively constant speed despite changes in loading.
Correct Answer: incomplete valve closure
Correct Answer: SAE 80
Correct Answer: small particles
Correct Answer: has lead-calcium plate grid
Correct Answer: Correct
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.