logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
  • Question

  • The engine oil level should be checked


  • Options
  • A. immediately after the ignition switch is turned off
  • B. while the engine is running
  • C. a few minutes after the ignition switch is turned off
  • D. while the engine is running at high-idle speed

  • Correct Answer
  • a few minutes after the ignition switch is turned off 

    • Automobile Engineering problems

    Search Results

    • 1. The crankshaft of a typical in-line four cylinder engine has __________ balance weights.

    • Options
    • A. 12
    • B. 4
    • C. 16
    • D. 8
      • Discuss
    • 2. The specific gravity of acid in a fully charged battery is generally

    • Options
    • A. 1.00
    • B. 1.28
    • C. 1.82
    • D. 2.81
      • Discuss
    • 3. Highest useful compression ratio (HUCR) is the highest compression ratio at which the

    • Options
    • A. engine can run
    • B. engine gives maximum output
    • C. engine is most efficient
    • D. fuel can be used in a test engine without knocking
      • Discuss
    • 4. The function of a governor in automobiles is to

    • Options
    • A. limit the power
    • B. limit the vehicle speed
    • C. maintain constant engine speed
    • D. maximise the fuel economy
      • Discuss
    • 5. The brake pedal during ABS operation

    • Options
    • A. is pushed upward forcefully
    • B. pedal stroke becomes longer
    • C. transmits slight kickback to the driver's foot
    • D. all of the above
      • Discuss
    • 6. In a four wheel drive (4WD), the number of gear boxes are

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
      • Discuss
    • 7. If the valve clearances are excessively large, the problem that can arise is

    • Options
    • A. overheating of the engine
    • B. incomplete valve closure
    • C. fouling of spark plug by gasoline
    • D. none of these
      • Discuss
    • 8. Which of the following oil is more viscous?

    • Options
    • A. SAE 30
    • B. SAE 40
    • C. SAE 70
    • D. SAE 80
      • Discuss
    • 9. A heat treated glass generally used in automobiles bursts into __________ upon cracking,

    • Options
    • A. sharp edged fragments
    • B. small particles
      • Discuss
    • 10. A maintenance free battery

    • Options
    • A. has lead-antimony plate grid
    • B. has lead-calcium plate grid
    • C. does not contain acid
    • D. does not contain water
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.