Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
In an engine, the temperature of the piston will be more at the
Options- A. crown of the piston
- B. skirt of the piston
- C. piston walls
- D. piston rings
- Correct Answer
- crown of the piston
- 1. The function of a connecting rod is
Options- A. to turn the flywheel
- B. to drive the drive plate
- C. to drive the fuel pump
- D. to transmit motion of the piston to the crankshaft Discuss
- 2. When the piston is at T.D.C, the volume above the piston in the combustion chamber is the
Options- A. clearance volume
- B. cylinder volume
- C. exhaust volume
- D. none of these Discuss
- 3. When the engine speed increases, the ignition timing must be advanced.
Options- A. Yes
- B. No Discuss
- 4. The capacity of a battery is usually expressed in terms of
Options- A. volts
- B. amperes
- C. weight
- D. ampere-hours Discuss
- 5. In comparison with a radial tyre, one advantage of a bias-ply tyre is
Options- A. longer life
- B. lower rolling resistance
- C. smoother ride at low speeds
- D. none of these Discuss
- 6. Which one of the following statement correctly describe the construction of a bevel-gear type differential?
Options- A. The drive shafts are splined to the differential carrier.
- B. The left side gear and the differential carrier rotate in constant unison.
- C. The differential carrier houses differential pinion gears and side gears, each pinion gear meshes with a different side gear.
- D. The differential carrier houses differential pinion gears and side gears Discuss
- 7. How many cells are used in a 12 volt car battery?
Options- A. 2
- B. 4
- C. 6
- D. 8 Discuss
- 8. In Diesel engines, during suction stroke, __________ is drawn in the cylinder.
Options- A. air and fuel
- B. only fuel
- C. only air
- D. none of these Discuss
- 9. If a tyre is designated as 175/65 R14 82 S, then the aspect ratio for the tyre is
Options- A. 175
- B. 65
- C. 14
- D. 82 Discuss
- 10. An over-inflated tyre will wear the tread most near the
Options- A. edges
- B. corners
- C. centre
- D. none of these Discuss
Automobile Engineering problems
Search Results
Correct Answer: to transmit motion of the piston to the crankshaft
Correct Answer: clearance volume
Correct Answer: Yes
Correct Answer: ampere-hours
Correct Answer: smoother ride at low speeds
Correct Answer: The differential carrier houses differential pinion gears and side gears
Correct Answer: 6
Correct Answer: only air
Correct Answer: 65
Correct Answer: centre
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.