logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Automobile Engineering Comments

  • Question
  • When the engine speed increases, the ignition timing must be advanced.


  • Options
  • A. Yes
  • B. No

  • Correct Answer
  • Yes 


  • Automobile Engineering problems


    Search Results


    • 1. The capacity of a battery is usually expressed in terms of

    • Options
    • A. volts
    • B. amperes
    • C. weight
    • D. ampere-hours
    • Discuss
    • 2. In comparison with a radial tyre, one advantage of a bias-ply tyre is

    • Options
    • A. longer life
    • B. lower rolling resistance
    • C. smoother ride at low speeds
    • D. none of these
    • Discuss
    • 3. The Diesel engine works on

    • Options
    • A. Otto cycle
    • B. Carnot cycle
    • C. Diesel cycle
    • D. Rankine cycle
    • Discuss
    • 4. The condition that results in large quantities of CO emission is

    • Options
    • A. insufficient air during combustion
    • B. insufficient fuel during combustion
    • C. low temperature combustion
    • D. high temperature combustion
    • Discuss
    • 5. The materials used for cylinder block are

    • Options
    • A. cast iron and steel
    • B. cast iron and aluminium alloy
    • C. steel and aluminium alloy
    • D. brass and steel
    • Discuss
    • 6. When the piston is at T.D.C, the volume above the piston in the combustion chamber is the

    • Options
    • A. clearance volume
    • B. cylinder volume
    • C. exhaust volume
    • D. none of these
    • Discuss
    • 7. The function of a connecting rod is

    • Options
    • A. to turn the flywheel
    • B. to drive the drive plate
    • C. to drive the fuel pump
    • D. to transmit motion of the piston to the crankshaft
    • Discuss
    • 8. In an engine, the temperature of the piston will be more at the

    • Options
    • A. crown of the piston
    • B. skirt of the piston
    • C. piston walls
    • D. piston rings
    • Discuss
    • 9. Which one of the following statement correctly describe the construction of a bevel-gear type differential?

    • Options
    • A. The drive shafts are splined to the differential carrier.
    • B. The left side gear and the differential carrier rotate in constant unison.
    • C. The differential carrier houses differential pinion gears and side gears, each pinion gear meshes with a different side gear.
    • D. The differential carrier houses differential pinion gears and side gears
    • Discuss
    • 10. How many cells are used in a 12 volt car battery?

    • Options
    • A. 2
    • B. 4
    • C. 6
    • D. 8
    • Discuss


    Comments

    There are no comments.

Enter a new Comment