Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
Valve overlap is the number of degrees of camshaft rotation during which
Options- A. both valves are closed
- B. both valves are open
- C. both 'a' and 'b'
- D. none of these
- Correct Answer
- both valves are open
- 1. The PCV valve incorporates a spring loaded plunger and opens in proportion to the level of vacuum pressure in the intake manifold.
Options- A. Agree
- B. Disagree Discuss
- 2. The basic purpose of tyre rotation on automobiles is to
Options- A. avoid ply separation
- B. equalize wear
- C. get better ride
- D. none of these Discuss
- 3. The fuel pump in the programmed fuel injection (PFI) system is located
Options- A. between the fuel-filler pipe and fuel tank
- B. in the fuel tank
- C. on the distributor mounting in the engine compartment
- D. on the engine compartment bulkhead Discuss
- 4. In a square type engine
Options- A. geometrical shape is square
- B. diameter and length of piston are same
- C. two cylinders are placed horizontal and two vertical
- D. stroke length and cylinder bore are same Discuss
- 5. Which of the following bulb in a car will have the least wattage?
Options- A. Head light bulb
- B. Stop light bulb
- C. Parking light bulb
- D. Ignition warning bulb Discuss
- 6. The engine oil is stored in __________ when the engine is not running.
Options- A. oil pan
- B. cylinder head
- C. oil pump
- D. separate oil tank Discuss
- 7. The camshaft is driven by the crankshaft via the timing belt.
Options- A. Correct
- B. Incorrect Discuss
- 8. The basic purpose of providing caster angle on wheels is to
Options- A. prevent uneven tyre wear
- B. maintain directional control
- C. bring the road contact of the tyre under the point of load
- D. compensate for wear in the steering linkage Discuss
- 9. The commonly used antifreeze solution in automobiles is
Options- A. carbon disulphide
- B. ethylene glycol
- C. ammonium chloride
- D. freon-12 Discuss
- 10. The indicated power of a four-stroke engine (in watts) is equal to (where P = Mean effective pressure in N/m2, L = Length of stroke in metres, A = Cross-sectional area of the piston in m2, and N = Speed of the engine in revolutions per second (r.p.s))
Options- A. P.L.A.N/2
- B. P.L.A.N
- C. 2 x P.L.A.N
- D. P.L.A.N/4 Discuss
Automobile Engineering problems
Search Results
Correct Answer: Agree
Correct Answer: equalize wear
Correct Answer: in the fuel tank
Correct Answer: stroke length and cylinder bore are same
Correct Answer: Ignition warning bulb
Correct Answer: oil pan
Correct Answer: Correct
Correct Answer: maintain directional control
Correct Answer: ethylene glycol
Correct Answer: P.L.A.N/2
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.