Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
A front stabilizer bar is used to
Options- A. increase vehicle load-carrying capacity
- B. provide a softer ride
- C. control suspension movement and body roll
- D. all of the above
- Correct Answer
- control suspension movement and body roll
- 1. If clearance volume of I.C. engines is increased, the compression ratio will
Options- A. increase
- B. decrease
- C. remain constant
- D. be doubled Discuss
- 2. The power actually developed inside the engine cylinder is called as
Options- A. indicated power
- B. brake power
- C. frictional power
- D. none of these Discuss
- 3. When the front wheels of a vehicle are locked during braking, then
Options- A. stopping distance becomes extremely long
- B. front tyres skid across the road surface, and the vehicle spins around
- C. rear tyres skid across the road surface, and the vehicle spins around
- D. driver loses control over the steering, and the vehicle continues moving in its current direction Discuss
- 4. The basic function of the suspension is to
Options- A. absorb vibration and impact forces from the road surface
- B. ensure that the steering wheel can deliver a suitable amount of steering force
- C. ensure that wheel alignment is not disturbed during driving
- D. automatically correct the effects of over steering Discuss
- 5. For the same maximum pressure and temperature
Options- A. Diesel cycle is more efficient than Otto cycle
- B. Otto cycle is more efficient than Diesel cycle
- C. both Otto cycle and Diesel cycle are equally efficient
- D. none of the above Discuss
- 6. Damper in an automobile is used to
Options- A. absorb the energy
- B. dissipate the energy
- C. release the energy
- D. increase the energy Discuss
- 7. The purpose of transmission in an automobile is
Options- A. to vary the speed of automobile
- B. to vary the torque at the wheels
- C. to vary the power of automobile
- D. none of these Discuss
- 8. A three way catalytic converter
Options- A. recirculates exhaust gasses
- B. burns fuel vapaour gasses
- C. reduces N2, H2O, and CO2 emission levels
- D. removes CO, HC, and NO2 from the exhaust gasses passing through it Discuss
- 9. Two general types of tyres are
Options- A. tube type and tubeless
- B. solid and tubeless
- C. air and pneumatic
- D. split-rim and drop centre Discuss
- 10. The timing belt is attached to the camshaft pulley and
Options- A. timing belt drive pulley
- B. distributor
- C. radiator fan pulley
- D. alternator pulley Discuss
Automobile Engineering problems
Search Results
Correct Answer: decrease
Correct Answer: indicated power
Correct Answer: driver loses control over the steering, and the vehicle continues moving in its current direction
Correct Answer: absorb vibration and impact forces from the road surface
Correct Answer: Diesel cycle is more efficient than Otto cycle
Correct Answer: dissipate the energy
Correct Answer: to vary the torque at the wheels
Correct Answer: removes CO, HC, and NO2 from the exhaust gasses passing through it
Correct Answer: tube type and tubeless
Correct Answer: timing belt drive pulley
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.