Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The basic function of the suspension is to
Options- A. absorb vibration and impact forces from the road surface
- B. ensure that the steering wheel can deliver a suitable amount of steering force
- C. ensure that wheel alignment is not disturbed during driving
- D. automatically correct the effects of over steering
- Correct Answer
- absorb vibration and impact forces from the road surface
- 1. For the same maximum pressure and temperature
Options- A. Diesel cycle is more efficient than Otto cycle
- B. Otto cycle is more efficient than Diesel cycle
- C. both Otto cycle and Diesel cycle are equally efficient
- D. none of the above Discuss
- 2. The cam shaft in an engine is always mounted
Options- A. parallel to the crankshaft
- B. perpendicular to the crankshaft
- C. inclined to the crankshaft
- D. none of these Discuss
- 3. Which of the following parameter can be adjusted by modifying the tie-rod attachment length?
Options- A. Camber
- B. Caster
- C. Toe
- D. Steering gear ratio Discuss
- 4. In petrol engines, during suction stroke, __________ is drawn in the cylinder
Options- A. air and fuel
- B. only fuel
- C. only air
- D. none of these Discuss
- 5. The fuel pump of a programmed fuel injection (PFI) system operate for two seconds when the ignition is turned to the start position to
Options- A. enable the pump's fault-diagnosis function to operate
- B. warm up and lubricate the pump
- C. supply a large amount of fuel and thereby create a choke effect
- D. pressurise the fuel system before the engine is started Discuss
- 6. When the front wheels of a vehicle are locked during braking, then
Options- A. stopping distance becomes extremely long
- B. front tyres skid across the road surface, and the vehicle spins around
- C. rear tyres skid across the road surface, and the vehicle spins around
- D. driver loses control over the steering, and the vehicle continues moving in its current direction Discuss
- 7. The power actually developed inside the engine cylinder is called as
Options- A. indicated power
- B. brake power
- C. frictional power
- D. none of these Discuss
- 8. If clearance volume of I.C. engines is increased, the compression ratio will
Options- A. increase
- B. decrease
- C. remain constant
- D. be doubled Discuss
- 9. A front stabilizer bar is used to
Options- A. increase vehicle load-carrying capacity
- B. provide a softer ride
- C. control suspension movement and body roll
- D. all of the above Discuss
- 10. Damper in an automobile is used to
Options- A. absorb the energy
- B. dissipate the energy
- C. release the energy
- D. increase the energy Discuss
Automobile Engineering problems
Search Results
Correct Answer: Diesel cycle is more efficient than Otto cycle
Correct Answer: parallel to the crankshaft
Correct Answer: Toe
Correct Answer: air and fuel
Correct Answer: pressurise the fuel system before the engine is started
Correct Answer: driver loses control over the steering, and the vehicle continues moving in its current direction
Correct Answer: indicated power
Correct Answer: decrease
Correct Answer: control suspension movement and body roll
Correct Answer: dissipate the energy
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.